Giant P200A-5100, P200A-3100 Specifications Model P217A-3100/5100, 3450 RPM+

Specifications

Model P217A-3100/5100

1750 RPM+	U.S.	(Metric)
Ratings	1.8 GPM @ 2000 PSI	(6.8 LPM @ 137 bar)
3450 RPM+
Ratings	3.3 GPM @ 2000 PSI	(12.5 LPM @ 137 bar)
Plunger Diameter	4.76”	18mm
Stroke	1.45”	5.5mm
Temperature of Pumped Fluids	Up to 160o F	(71o C)
Inlet Ports (P217A-3100)		(2) 3/8” BSP
Inlet Ports (P217A-5100)		(2) 1/2” BSP
Discharge Ports		(2) 3/8" BSP
Shaft Rotation		Top of Pulley Towards Fluid End
Crankshaft Diameter	0.94”	24mm
Key Width	0.31”	8mm
Shaft Mounting		Either Side
Weight	11 lbs. 11oz	(4.9 kg)
Crankcase Oil Capacity	8.1 fl.oz	(0.24 liters)
Volumetric Efficiency @ 1750 RPM		0.90
Mechanical Efficiency @ 1750 RPM		0.88
*15 PSI inlet pressure required

Consult the factory for special requirements that must be met if the pump is to operate beyond one or more of the limits specified above.

PULLEY INFORMATION

Pulley selection and pump speed are based on a 1725 RPM motor and "B" section belts. When selecting desired GPM, allow for a ±5% tolerance on pumps output due to variations in pulleys, belts and motors among manufacturers.

1.Select GPM required, then select appropriate motor and pump pulley from the same line.

2.The desired pressure is achieved by selecting the correct nozzle size that corresponds with the pump GPM.

HORSEPOWER INFORMATION

Horsepower ratings shown are the power require- ments for the pump. Gas engine power outputs must be approximately twice the pump power require- ments shown above.

We recommend that a 1.1 service factor be specified when selecting an electric motor as the power source. To compute specific pump horsepower requirements, use the following formula:

GPM X PSI =hp 1450

P217A-3100/5100 PULLEY SELECTION & HORSEPOWER

REQUIREMENTS

PUMP	MOTOR	RPM	GPM	800 PSI	1200 PSI	1500 PSI	1700 PSI	2000 PSI
PULLEY	PULLEY
7.75	4.00	1750	1.8	1.0	1.5	1.9	2.1	2.5
7.75	6.80	3000	3.0	1.7	2.5	3.1	3.5	4.1
7.75	7.25	3200	3.2	1.8	2.6	3.3	3.8	4.4
7.75	7.75	3450	3.3	1.8	2.7	3.4	3.9	4.6

3