Infinity CC-1 owner manual Wiring the System

Page 5

TURN OFF ALL POWER...

IMPORTANT!

IMPORTANT!

Figure 3. The CC-1 center-channel speaker features gold-plated terminals that can be connected in several different ways; e.g., banana plugs, spade terminals, and direct wiring (as shown here).

WIRING THE SYSTEM

After placing the speaker, you are ready to connect it to your system. First turn off all audio system power. Use high-quality speaker wire to make the connections. Consult the owner’s manuals (included with your amplifier, receiver, or television) for connection and operation procedures.

When using the CC-1 for center-channel reproduction, set the center- channel mode (on a Dolby Pro Logic preamplifier or A/V receiver) to NORMAL. This will route the low frequencies (below 100 Hz) away from the center-channel speaker to the front left and right speakers.

Observe polarities when making speaker connections, as shown in Figures 3 (below) and 4 (on the next page). Connect each + terminal on the back of the amplifier, receiver, or television to the respective + (red) terminal on the CC-1 speaker. Similarly, connect the (black) terminals in the same way.

Do not reverse polarities (i.e., + to - or - to +) when making connections.

CC-1

(rear view)

Red = +

Black =

Insert Bare End Loosen

End; Tighten

Terminal

Terminal

 

Stripe =

No Stripe = +

Speaker Wire

CONNECTING SPEAKERS DIRECTLY TO WIRES

4 Infinity CC-1 Center-Channel Speaker Owner’s Manual

Image 5
Contents Model CC-1 Way Center-Channel Speaker Unpacking the Speaker IntroductionPlanning Your System Placement Wiring the System Testing the Speaker Care of Your Speaker System TroubleshootingSpecifications Who is protected by the warranty? Limited Five Year Warranty