Dimensional Drawing, Specifications, Input Panel

SPECIFICATIONS JFX88

DIMENSIONAL DRAWING

22.5°

45°

	4.00
C
L
TOP		4.42	2.32
		4.42	2.32
9.79	6.15	3.00	.63	3.61

A & E SPECIFICATIONS

The 2-way full-range loudspeaker shall incorporate an 8-in LF cone and a 1.4-in voice coil HF compression driver. The LF cone shall be mounted in a vented enclosure tuned for opti- mum low frequency response. The HF driver shall be loaded on an axis-symmetrical, 1-in exit Wave Guide Plate™ with a nom- inal conical beamwidth of 100 degrees. An internal passive filter network shall provide all acoustical crossover and sys-

17.46

8.00

GRILLE PARTIALLY SHOWN

FRONT
C	5.62
L	5.62
3.95
	9.20
TOP HAT

	2.41
		INPUT
	4.00	2X 5.00
	4.00
		2.87
RIGHT	2X 2.75	.91	LEFT SIDE
RIGHT			LEFT SIDE
SIDE
SIDE

BACK

NOTES:

1. SYMBOL INDICATES MOUNTING POINT, 3/8-16 THREADED HOLE (T-NUT)

2.SYMBOL INDICATES MOUNTING POINT, 5/16-18 T-NUT FOR OMNI MOUNT SERIES 100.

3. SYMBOL INDICATES CENTER OF BALANCE 4. WEIGHT APPROX. 27 LBS.

tem equalization requirements.

System frequency response shall vary no more than +3 dB from 115 Hz to 20 kHz measured on axis. The loudspeaker shall produce a sound pressure level of 94 dB SPL on axis at 1 meter with a power input of 1 watt, and shall be capable of producing a peak output of 125 dB SPL on axis at 1 meter. It shall handle 300 watts of amplifier power and shall have a nominal impedance of 8 ohms.

The loudspeaker enclosure shall be irregularly trapezoidal in

	5.00	5. SHIPPING WEIGHT APPROX. 31 LBS.

BOTTOM		0002891 (A) 8/12/02

Manufacturing tolerances are +/- 0.13 and +/- 1°

INPUT PANEL

WHITINSVILLE, MA USA

PIN 1--...--

PIN 1+...+

PIN 2--...NC

PIN 2+...NC

shape. It shall be constructed of exterior grade Baltic birch plywood and shall employ extensive internal bracing. It shall be finished in wear-resistant textured black paint. Input con- nectors shall be 2x Neutrik NL4 Speakon wired in parallel. It shall include a pole mount cup for portable applications. One 3/8"-16 threaded mounting/suspension point shall be provid- ed on the top and bottom of the enclosure. Four 5/16"-18 threaded mounting points for use with an Omnimount® Series 100 (or similar) shall be provided on the rear of the enclo- sure. The front of the loudspeaker shall be covered with a foam backed, powder coated perforated steel grille.

The 2-way full-range loudspeaker shall be the EAW model JFX88.

JFX88

S/N

One Main Street, Whitinsville, MA 01588	508 234 6158	Toll Free 800 992 5013	FAX 508 234 8251	info@eaw.com	www. eaw. com
EAW products are continually improved. All specifications are therefore subject to change without notice.			JFX88/0004637/2 pp	September 2002	Printed in USA

SPECIFICATIONS JFX88