EAW JFX100 specifications Input Panel, Specifications

DIMENSIONAL DRAWING
C
L	45°
22.5°
	5.29
TOP			3.13
	8.21			4.94
11.68		3.00	C	4.25
			L

		4.00
				1.71
				INPUT
	19.75			C
				L
9.50			2X 5.00
				2.94
		HANDLE
GRILLE PARTIALLY SHOWN			3.38		LEFT SIDE
FRONT		RIGHT SIDE		1.59
			2X 2.75
5.75	TOP HAT			BACK
		NOTES:
		1. SYMBOL INDICATES MOUNTING POINT,
11.82		5/16-18 T-NUT FOR OMNI MOUNT SERIES 100.
		2. SYMBOL INDICATES 3.00 X 1.35 FLY TRACK.
5.29	4.75
		3. SYMBOL INDICATES CENTER OF BALANCE.

4.WEIGHT APPROX. 39 LBS.

5.SHIPPING WEIGHT APPROX. 43 LBS.

C

L

BOTTOM

0001755 (A) 8/26/02

Manufacturing tolerances are +/- 0.13 and +/- 1°

INPUT PANEL

WHITINSVILLE, MA USA

PIN 1--...--

PIN 1+...+

PIN 2--...NC

PIN 2+...NC

SPECIFICATIONS JFX100

A & E SPECIFICATIONS

The 2-way full-range loudspeaker shall incorporate a 10-in LF cone and a 1.75-in voice coil neodymium HF compression driver. The LF cone shall be mounted in a vented enclosure tuned for optimum low frequency response. The HF driver shall be loaded on an axis-symmetrical, 1-in exit Wave Guide Plate™ with a nominal conical beamwidth of 100 degrees. An internal passive filter network shall provide all acoustical crossover and system equalization requirements.

System frequency response shall vary no more than +3 dB from 90 Hz to 16 kHz measured on axis. The loudspeaker shall produce a sound pressure level of 96 dB SPL on axis at 1 meter with a power input of 1 watt, and shall be capable of producing a peak output of 127 dB SPL on axis at 1 meter. It shall handle 300 watts of amplifier power and shall have a nominal impedance of 8 ohms.

The loudspeaker enclosure shall be irregularly trapezoidal in shape. It shall be constructed of exterior grade Baltic birch plywood and shall employ extensive internal bracing. It shall be finished in wear-resistant textured black paint. Input con- nectors shall be 2x Neutrik NL4 Speakon wired in parallel. It shall include a pole mount cup and a handle integral to the rear of the enclosure. One 3-postion fly track with an integral 3/8"-16 threaded mounting/suspension point shall be provid- ed on the top of the enclosure. Four 5/16"-18 threaded mounting points for use with an Omnimount® Series 100 (or similar) and a pull-back ring shall be provided on the rear of the enclosure. The front of the loudspeaker shall be covered with a foam backed, powder coated perforated steel grille.

The 2-way full-range loudspeaker shall be the EAW model JFX100.

JFX100

S/N

One Main Street, Whitinsville, MA 01588	508 234 6158	Toll Free 800 992 5013	FAX 508 234 8251	info@eaw.com	www. eaw. com
EAW products are continually improved. All specifications are therefore subject to change without notice.			JFX100/0004638/2 pp	September 2002	Printed in USA