Goodman Mfg IO-101G manual Index

INDEX			company. Check the unit model number, specifications,
Important Message to Homeowner	2		electrical characteristics and accessories to determine if
			they are correct. In the event an incorrect unit is shipped,
Codes and Regulations	2		it must be returned to the supplier and must NOT be
Inspection	2		installed. The manufacturer assumes no responsibility for
			installation of incorrectly shipped units.
Replacement Parts	2
			REPLACEMENT PARTS
Important Safety Instructions	2
			Order all replacement parts through your local distributor.
Clearances and Accessibility	2		When ordering parts, give complete model and serial
			number as shown on the unit’s rating plate. Replacement
Location	3
			parts for this appliance are available through your
Electrical	3		contractor or local distributor. For the location of your
Refrigerant Tubing	4		nearest distributor consult the white business pages, the
			yellow page section of the local telephone book or contact:
Evaporator Coils	4		SERVICE PARTS DEPARTMENT
Quick Connect Coils	4		GOODMAN MANUFACTURING COMPANY, L.P.
System Start Up	4		2550 NORTH LOOP WEST, SUITE 400
			HOUSTON, TEXAS 77092
Processing Checks	4
			(713) 861 – 2500
Charge Checks	5		IMPORTANT SAFETY INSTRUCTIONS
Superheat Determination	5		Recognize Safety Symbols, Words, and Labels
			The following symbols and labels are used throughout this
Expansion Valve System	5
			manual to indicate immediate or potential hazards. It is
Wiring Diagrams	6		the owner’s and installer’s responsibility to read and
			comply with all safety information and instructions
IMPORTANT MESSAGE TO OWNER			accompanying these symbols. Failure to heed safety
			information increases the risk of property damage and/or
These instructions should be carefully read and kept near
			product damage, serious personal injury or death.
product, for future reference. While these instructions are
addressed primarily to the installer, useful maintenance			DANGER
information is included. Have your installing dealer
acquaint you with the operating characteristics of the			IMMEDIATE HAZARDS WHICH WILL RESULT IN
product and periodic maintenance requirements.
			PROPERTY DAMAGE, PRODUCT DAMAGE, SEVERE
CODES AND REGULATIONS
			PERSONAL INJURY AND/OR DEATH.
This product is designed and manufactured to permit			WARNING
installation in accordance with National Codes. It is the
installers responsibility to install the product in accordance			HAZARDS OR UNSAFE PRACTICES COULD RESULT
with National Codes and/or prevailing local codes and
			IN PROPERTY DAMAGE, PRODUCT DAMAGE,
regulations. The manufacturer assumes no responsibility
			SEVERE PERSONAL INJURY AND/OR DEATH.
for equipment installed in violation of any code or
regulations.			CAUTION
Important: The United States Environmental Protection			HAZARDS OR UNSAFE PRACTICES WHICH MAY
Agency (EPA) has issued various regulations regarding
			RESULT IN PROPERTY DAMAGE, PRODUCT
the introduction and disposal of refrigerants in this unit.			DAMAGE, AND/OR PERSONAL INJURY.
Failure to follow these regulations may harm the
environment and can lead to the imposition of			CLEARANCES AND ACCESSIBILITY
substantial fines. Because regulations may vary due			The condensing unit is designed to be located outside the
to passage of new laws, we suggest a certified			building with unobstructed condenser air inlet and
technician perform any work done on this unit. Should			discharge. Additionally, the unit must be situated to permit
you have any questions please contact the local office			access for service and installation. Condenser air enters
of the EPA.			from three sides. Air discharges upward from the top of
			the unit. Refrigerant tube electrical connections are made
INSPECTION			on the right side of the unit as you face the compressor
Upon receiving the unit, inspect it for damage from			compartment. The best and most common application is
shipment. Claims for damage, either shipping or			for the unit to be located 10” from the back wall with the
concealed, should be filed immediately with the shipping			connection side facing the wall. Refer to Figures 1 and 2.
IO-101G		2	06/04