How to Make Your Player Stand, Using the AC Adapter

Portable DVD Player

i1155_V11M11_IM_EN_10052007

GETTING STARTED

How to Make Your Player Stand

Follow the illustrations below 4 step to make your player stand.

(1)

(2)

(3)

(4)

First Time Use of Remote Control

The battery is pre-installed in the remote control with an insulation plate. Before operating the remote control, please pull out the insulation plate from the battery compartment.

Remote Control Battery Installation

If the remote control does not work or the signal gets weaker, the battery might weak. In that case, please replace the battery.

1.Pull out battery holder as shown at right.

2.Place one battery (CR 2025) as shown at right. Match the polarity (+/–) of battery with the marks inside the unit.

3.Insert battery holder into its compartment as shown at right.

Note: Do not attempt to recharge, short-circuit, disassemble, heat, or throw batteries into a fire.

Using the AC Adapter

1.Insert the DC plug at the end of the adapter cord into the DC IN jack on the back of the player.

2.Plug the other end into an AC wall outlet.

Note: Use ONLY the supplied AC adapter. Use with other AC adapters could cause damage. Remove both the DC plug and AC plug to disconnect the AC adapter when not necessary.

Using the Cigarette Lighter (Car) Adapter

Plug the small end of the cigarette lighter (car) adapter into the DC IN jack and plug the other end into the cigarette lighter socket.

- 12 -www.i-Luv.com