AV COMPU LINK REMOTE CONTROL SYSTEM
AV COMPU LINK remote control system
English
When you are going to enjoy a disc, you usually have to turn on your television, receiver and Video CD player and setup these components’ individually. If, however, the system consists of components which support JVC’s AV COMPU LINK remote control system, instead of individual setup, simply pressing the 3(PLAY)/SELECT button allows you to enjoy the disc.
Connection and setup
Using the AV COMPU LINK cable, connect the AV COMPU LINK terminals of each component to one another.
After the connection is done, make the player’s AV COMPU LINK setting by the following procedures.
1. While the player is in the STANDBY mode, hold down the 7
(STOP) button and press the / (STANDBY/ON) button. The corresponding CD button (CD1 to CD3) of the selected AV COMPU LINK setting blinks.
2.To change the selection, press the 3(PLAY)/SELECT button.
Each press of the button cycles the selection as shown below.
CD 1 CD 2 CD 3
3.To exit the setting mode, press the 7 (STOP) button to return to the STANDBY mode, or press the / (STANDBY/ON) button to enter the ON mode.
To AV COMPU LINK (II or EX)
TV
Video CD player
If you connect the Video CD player to a television via AV COMPU LINK as illustrated above, set the Video CD player’s AV COMPU LINK setting as follows.
•When connecting with VIDEO 1 input terminal of the television: CD 2
•When connecting with VIDEO 2 input terminal of the television: CD 3
To AV COMPU LINK | To AV COMPU LINK |
(II or EX) |
TV
Video CD player | Video cassette recorder |
If you connect the Video CD player to a television and VCR via AV COMPU LINK as illustrated above, set the VCR’s Remote Control Code and Video CD player’s AV COMPU LINK setting as follows.
•When connecting with VIDEO 1 input terminal of the television: Video CD player’s AV COMPU LINK setting: CD 2
VCR’s Remote Control Code:B
• When connecting with VIDEO 2 input terminal of the television:
Video CD player’s AV COMPU LINK setting: CD 3
VCR’s Remote Control Code: | A |
TV
Receiver | Video CD player |
If you connect the Video CD player to a television and receiver via AV COMPU LINK as illustrated above, set the Video CD player’s AV COMPU LINK setting to CD1.
Operation
You can enjoy pictures and/or sound by just putting the Video CD player into play mode. You do not have to operate the TV and/or receiver including power switching.
Preparation
Set the POWER switch of each component to ON.
1.Insert a disc into the Video CD player.
2.Press 3 (PLAY)/SELECT of the Video CD player.
SELECT
The following actions are performed automatically:
•Turning on the power of each component.
•Setting the source of the television to the external input which the Video CD player is connected to.
•Setting the source of the receiver to the Video CD player.
Notes for connection
•Connect the AUDIO OUT jacks of the Video CD player to the audio input jacks of a receiver which show “DVD”. Otherwise, the system will not work correctly.
•There may be no description about connections to a Video CD player in the instruction manual of a television or VCR. But a television or VCR with AV COMPU LINK terminals which show II can be con- nected to a Video CD player.
Page 25