Directed Electronics OHDW17.2 manual Loading and Unloading Discs, Battery Replacement, Precautions

BATTERY REPLACEMENT

NOTE: Before using remote after installation, remove the battery plastic protective slip.

Remote Controller

+ side Battery

Latch Battery Holder

1.Move the small latch to the right and slide out the battery holder.

2.Remove old battery and replace it with a new battery (CR2025) with the positive “+” sign facing as shown above.

3.Push battery holder back into its compartment until it is locked.

PRECAUTIONS

1.Properly dispose of used battery.

2.Do not misuse battery by shorting the positive “+” and negative “-” terminal or put it into fire. Overheating may cause the battery to explode and cause a fire hazard.

3.If the remote is not to be used for a long period, remove the battery from the remote to prevent damage from battery leakage.

4.To avoid accidents, prevent children from playing with the battery.

Loading and Unloading Discs

You can use single side and dual layer DVDs, VCDs, CD-audio and CD-R compatible 12cm discs with this system.

LOADING DISC

1.Press OPEN at the upper right corner to open the door.

2.Load with the recorded side (the shiny side) facing up. With double-sided discs, load with the

18 © 2005 Directed Electronics—all rights reserved