C. Crane PR-D4VW instruction manual Hour Digit, Dual alarm set

Getting Started

2)Immediately press and hold the Scan/Set button for 3 seconds and you will hear a beep. The ALARM

HOUR DIGIT and	or	will flash,	SCAN
depending on which type of alarm is being set.

3)Using the Up/Down Tuning Buttons, select the appropriate hour digit and AM or PM.

4)Press the Scan/Set Button again to select the minutes digits. The MINUTES DIGITS will flash.

5)Use the Up/Down Tuning Buttons to adjust the minutes to the appropriate time.

6)When finished press the Scan/Set Button. The or symbol will be displayed.

Notes: If the Radio Alarm has been chosen, when the alarm time is reached the radio will play the last station selected at the same volume level last set.

If there is no alarm symbol on the display, the alarm has not been activated.

Dual alarm set:

Follow steps 1-6 for both the Radio and Beep Tone Alarms. This allows you to set two different activation times and alarm types. This symbol (shown at right) will be displayed if both alarms are activated.

Sonido Radio Page 9