Uniden UH-090 owner manual Introduction, Features

Page 3

Introduction

The Uniden UH-090 is designed to provide you with years of trouble free service. Its rugged components and materials are capable of withstanding harsh environments.

We are certain that you will enjoy your UH-090. Please read this Operating Manual carefully to ensure you gain the optimum performance of the unit.

Features

Transmitt & Receive FM 40CH (UHF-CB, TX Power 5w)

Transmitt & Receive AM 40CH (AM Band, TX Power 5w)

LCD Display with Backlight Signal Strength Meter RF Power Indicator

Speaker Audio Volume Level Meter One touch FM or AM Mode selectable Dual Band Watch

Instant Channel programmable separately FM/AM Modes

One touch Instant Channel recalling

Duplex Capability (from CH01 - CH08 per channel) FM Only

FM Group Scan and Priority CH Watch FM Open Scan

AM Group Scan with Priority CH Watch

AM Open Scan

Scan Channel Memory On/Off separately with FM Open Scan, FM Group Scan, AM Open Scan and AM Group Scan

Rotary Channel Select

Busy CH Lock-out Function - (FM Only)

Roger Beep Function On/Off (FM VOX Mode Only)

2 Different Ring Tones (FM Only)

38 Built-in CTCSS (Continuous Tone Coded Squelch System) codes that are user selectable (FM Only)

2 Levels Preset Squelch (FM Only) Variable Squelch Level adjust (AM Only) Volume Control with Power On/Off Switch VOX (Voice Activated Function) (FM Only)

10 Steps VOX Mic sensitivity adjustment (FM Only) Memory Backup if power fails

Preventive Maintenance: The following system checks should be made every six to twelve months:

Check the Standing Wave Ratio (SWR).

Inspect the tightness of all electrical connections.

Inspect the antenna coaxial cable for wear or breaks on the shielding. Inspect the tightness of all screws and other mounting hardware.

Troubleshooting: Should the unit malfunction or perform poorly, follow these procedures: If the transceiver is completely inoperative...

Check the power cord and fuse. If there is trouble with receiving...

Check the VOLUME control setting. Be sure the SQUELCH is adjusted properly. Possibly the radio is over- squelched.

If there is trouble with transmitting...

Check that the transmission line (coaxial cable) is securely connected to the ANTENNA connector.

Check that the antenna is fully extended for proper operation.

Check that all transmission line (coaxial cable) connections are secure and free of corrosion.

 

Blackening may occur on the Liquid Crystal Display. If the UH-090 has been subjected to extreme

NOTE

high temperature (above 60°C). This is not a fault. Normal LCD operation resumes when the

temperature stabilizes back to standard operating conditions (0 to 55°C).

 

 

2

Image 3
Contents Uniden Model UH-090 Dual Band CB Radio FM & AM Contents Introduction FeaturesChannel Controls / Connectors / IndicatorsIndicators Included with your UH-090 Setting the AM Squelch Setting the FM SquelchOperation Transmitting Using Repeater Channels FM OnlyMonitor Selecting a ChannelScanning Operating the UH-090 in Duplex ModeOpen Scan OS Mode Group Scan GS ModeProgramming Scan Channels VOX Operation optional VOX headset required FM Only Selecting the Call Ring tone FM OnlyRoger Beep FM VOX Only Busy Channel Lockout FM OnlyCtcss FM Only Programming the Instant Priority ChannelRecalling the Instant Channel Dual Band WatchFrequency Lists FM UHF CB Frequency List AM CB Frequency ListAustralia & New Zealand Australia only Specifications Ctcss Tone List for FM ModeTechnical Support & Service WarrantyUniden Australia Pty Limited / Uniden New Zealand Limited