NuTone IMA4406 Connecting the Radio Antenna, Connecting the Optional Chime Module

Page 9

INSTALLATION (Continued)

CONNECTING THE RADIO ANTENNA

1.Refer to Figure 18. Plug radio antenna (supplied with IR105 rough-in frame) into the 2-pin connector located on the main circuit board. Be certain the tab on the connector is facing towards the top of the master unit, as illustrated.

TAB

FIGURE 18

NOTE: Any excess antenna cable should be located outside of Rough-in.

In most locations the antenna supplied with the rough-in frame provides adequate AM reception; however, in rural or weak signal areas, a separate AM antenna may be required. Refer to the following instruction when selecting and connecting an AM antenna.

1.Refer to Figure 19. Move the auxiliary antenna selector switch to the AM position.

2.Connect 50 feet of 22 ga. insulated wire to the screw terminal marked AM ANTENNA.

3.Run the wire from the master station location to the attic. Fasten the insulated wire at one end of the attic; stretch the wire to its full length and fasten at the opposite end.

Fasten the insulated wire at several locations between ends to prevent sagging.

AM/FM

AM ONLY

AM ANTENNA

FIGURE 19

CONNECTING THE OPTIONAL

CHIME MODULE

It is now time to connect the optional chime module that you earlier installed into the master station.

1.Refer to Figure 20. Identify the front chime pushbutton wires.

2.Connect the front pushbutton wires to the screw terminals marked FRONT and COMMON on the chime module.

3.Repeat steps 1 and 2 for the REAR and SIDE chime pushbuttons.

4.Refer to the instructions packed with the chime module for information on chime volume level and chime tune selection (IA-29 only).

FRONT

REAR

SIDE

COMMON

CHIME

VOLUME

FIGURE 20

CONNECTING OPTIONAL

ELECTRONIC CHIME

1.Refer to Figure 21. Connect NuTone IW-2 cable from the chime to the (+) and (-) screw terminals on the master station’s main circuit board.

2.Refer to the instructions packed with the chime for complete wiring information.

IMPORTANT: Failure to use NuTone IW-2 cable will cause the system to hum at all times.

(–) (+)

ELECTRONIC

CHIME

FIGURE 21

9

Image 9
Contents Model IMA-4406 Series Master Station AM/FM RADIO/CD Player Intercom SystemTable of Contents InstallationPrecautions and Guidelines Contents of CartonWiring Specifications Remote Station WiringConnecting the Remote Wiring Connecting Volume Control WiringMounting the Terminal Board Connecting Door Speaker Wiring Mounting the Master Station Mounting the Transformer Cover Connecting Power TransformersConnecting the Master Station to the Terminal Board Connecting the Radio Antenna Connecting the Optional Chime ModuleConnecting Optional Electronic Chime Connecting Power to the Optional CP-95 Cassette Player Connecting Optional AccessoriesConnecting the Memory Back UP Battery Mounting and Connecting Optional Door Release PushbuttonPowering UP the System Securing the Master PanelSystem Operating Controls Operational CheckoutSetting Program Audio Controls Digital ClockSystem Checkout Setting Internal Intercom Volume Control Setting Intercom VolumeSetting the Beep Tone Level Setting the External Audio Source LevelResetting the Microprocessor Diagnostic TestsINSTALLER’S Troubleshooting Guide Make separate cable IW-6 runs from each Remote Station to Cannot receive radio station Faulty antenna connection Page Product specifications subject to change without notice