La Crosse Technology WD-2512UR-B owner manual Optional TX-50U Wireless Outdoor Sensor

Page 10

Version 1.3 - 11/13/2008

Zone available per Wireless Display.

The Daylight Saving Time (DST) checkbox on your Wireless Display settings at www.weatherdirect.com is selected by default because most locations observe DST. If you are in a location that does not observe DST, please make sure to uncheck this box.

Optional TX-50U Wireless Outdoor Sensor

The Optional Wireless Outdoor Sensor sends temperature data to your Wireless Display, accurate to within a tenth of one degree.

The Optional Outdoor Temperature Sensor uses 2 x “AA”, Alkaline batteries. To install and replace the batteries, please follow the steps below:

1. Remove the battery compartment cover on the back of the sensor.

2. Insert the batteries, observing the correct polarity (see marking).

3. Replace the battery compartment cover on the unit.

After the Optional Outdoor Temperature Sensor is powered up, press the “+” Key on your Wireless Display to show the outdoor temperature at any time. The outdoor temperature will scroll on the bottom of the LCD.

Because the “+” key is used to toggle between time, date and temperature, when you press the “+” key to view the outdoor temperature, you also switch to the next view mode on the top segment of the LCD. Simply press the “+” key until you are also viewing the desired mode: time, date or temperature.

Wireless Display Operation

This section will teach you how to use your Wireless Display once you have completed online registration. There are 4 control Keys located on the front of the Wireless Display: “SET”, “+”, “ALARM” and “MODE”. The following information is divided into sections based on the function of each Key.

Page 10 of 25

Image 10
Contents DAY Internet Powered Weather Station Table of Contents Version 1.3 11/13/2008 Quality Forecasts CongratulationsWeather Direct Lite is Green MHz Wireless Sensor Technology Included in the BoxWhat You Need to Get Started Set Up your WD-2512UR-B Hardware Installation To Surface Mount the Outdoor SensorOnline Resources Wireless USB Transceiver InstallationTo Wall Mount the Outdoor Sensor Features Time Setting on Wireless DisplayOptional TX-50U Wireless Outdoor Sensor Wireless Display OperationMode Key Turn Alarm ON/OFF Set Alarm TimeManually Request a Weather Direct Lite Data Update Toggle Between Time, Date & TemperatureWhen ADD 4 Locations Expansion Option is Active Changing Settings on Your Wireless Display Four SET modes are Set Mode 1 Set LCD ContrastFactory Reset of Wireless Display Set Mode 4 View Device IDTo Perform the Factory Reset Free Trial of Expansion Options for 14 DaysAdd Optional Secure Weather Gateway Watches Forecast Icons Explained Care and Maintenance Battery Low IconsBattery Replacement Troubleshooting SpecificationsPower Requirements Liability DisclaimerFCC Statements Warranty Information Version 1.3 11/13/2008