DIGITAL TUNER | DIGITAL TUNER |
2.To prevent sound interference the bass control options operate exclusively. You cannot combine the bass from EQUALIZER with wOOx
4.GAMESOUND
To adjust the game sound, press GAMESOUND once or more to select your option.
=Display briefly shows | , | , |
or | . |
|
Note: GAMESOUND is only available when you play in GAME•AUX source.
How to MUTE the sound
1.Press MUTE on the remote control to interrupt sound reproduction instantly.
=Playback continues without sound and the
display flashes | . |
2.To reactivate sound reproduction you can:
–press MUTE again;
–adjust the volume controls;
–change to another source.
DIGITAL TUNER (See 3)
Tuning to stations
1.Press STANDBY ON y to on, then press SOURCE once or more to select TUNER (or press TUNER once on the remote control).
=Display: shows 
briefly followed by waveband, frequency, and preset station number if already stored.
2.Press BAND / DISPLAY once or more to select your waveband ( TUNER on the remote control)
3.Tuning to stations: you can tune to your stations manually or by automatic search tuning: Press down on ∞ or § (5 or 6 on the remote control ) and release button when the frequency in the display starts running.
=The radio automatically tunes to a station of sufficient reception. Display shows 
during automatic tuning.
4.Repeat step 3 if necessary until you find the desired station.
•To tune to a weak station, press ∞ or § (5 or 6 on the remote control ) briefly and repeatedly
until you have found optimal reception.
To improve radio reception:
•For FM, extend, incline and turn the telescopic antenna. Reduce its length if the signal is too strong.
•For MW, the set uses a
Programming tuner stations:
You can store up to a total of 30 radio stations in the memory, manually or automatically (Autostore).
Autostore
Automatic programming will start from preset 1. The set will only program stations which are not in the memory already.
1.Press ALBUM / PRESET- or + once or more to select the preset number .
2.Press PROG for 4 seconds or more to activate auto store programming.
=Display: 
is shown and available stations are programmed in order of waveband FM, followed by MW , preset 1 station will then be played after all stations are stored automatically.
Manual programming
1.Tune to your desired station (see Tuning to stations).
2.Press PROG to activate programming.
=Display: program flashes.
3.Press ALBUM / PRESET- or + once or more to allocate a number from 1 to 30 to this station.
4.Press PROG again to confirm.
=Display shows the preset number, waveband and the frequency of the preset station.
5.Repeat the above four steps to store other stations.
Note : You can erase a preset station by storing another frequency in its place.
To listen to a preset station
Press ALBUM / PRESET- or + once or more until the desired preset station is displayed.