Digital Tuner, Tuning to radio stations | Philips AZ1565 instruction

DIGITAL TUNER

1.Select TUNER source.

ª is displayed briefly and then the radio station frequency is shown.

2.Press BAND once or more to select your waveband.

3.Press SEARCH ° or ¤ (on the remote control, TUNING °

or ¤) and release when the frequency in the display starts running.

ªThe tuner automatically tunes to a station of sufficient

reception. Display shows during automatic tuning.

ªIf an FM station is received in stereo, STEREO is shown.

4.Repeat step 3 if necessary until you find the desired station.

• To tune to a weak station, press SEARCH ° or ¤ briefly and repeatedly until you have found optimal reception.

•For FM, pull out the telescopic aerial.

Incline and turn the aerial. Reduce its length if the signal is too strong (very close to a transmitter).

•For MW (LW), the set is provided with a built-in aerial so the telescopic aerial is not needed. Direct the aerial by turning the whole set.

You can store up to a total of 30 radio stations in the memory.

1.Tune to your desired station (see Tuning to radio stations).

2.Press PROG to activate programming.

ªDisplay: PROG flashes.

3.Press PRESET 3 or 4 once or more to allocate a number from 1 to 30 to this station.

4.Press PROG again to confirm the setting.

ªDisplay: PROG disappears, the preset number and the frequency of the preset station are shown.

5.Repeat the above four steps to store other stations.

•You can overwrite a preset station by storing another frequency in its place.

Press TUNER PRESET 4 or 3 until the desired preset station is displayed.