Gardena WP 1500 S, WP 700 S manual Care Instructions Dismantling, Storage, Information

G

Avoid dry operation	Avoid dry operation of the pump as dry running will produce
	undesirable heat and destroy the pump.
Horizontal or	.Loosen the regulator by turning it anti-clockwise until you
second outlet	achieve the desired water flow from the vertical pipe of the
	fountain/water feature.
	.You may connect other terminals to the second outlet.
	For example, a separately installed water jet may be operated
	via the GARDENA Fountain/Light Bracket, Art. No. 7886.
	If necessary fix the bracket with two screws.
	Information:
	This significantly reduces the volume of the vertical water jet.
	.If the max. delivery capacity of the second outlet is to be used
	then the vertical outlet should be closed with the end cap sup-
	plied.
	.Example: Hose pipe connection with the GARDENA
	Fountain/Light Bracket
	We recommend the use of a 3/4” (19 mm) GARDENA Pond
	Hose Pipe, Art. No. 7895, connected to with the GARDENA
	“Profi” Maxi-Flow-System with Tap Connector (Art. No. 2801
	and 2802) and the GARDENA “Profi” Maxi-Flow-System Hose
	Connectors (Art. No. 2817).

Care Instructions

G

Dismantling

1.Disconnect the plug from the solar panel!

2.Remove the pump from the water.

3. If necessary remove the gravel.

4. Pull the pump pointing vertically upwards out of the filter tank.

6	5. Pull the suction filter casing 1 for-
5	wards and remove it.
	6. Remove the foam filter 2 from the
4
	suction piece of the pump.
3	7. Turn the pump casing 3 to the left
2	to the limit stop and then

pull it straight towards the front and

remove it! Do not tilt!

8. Pull the feed impeller 4 out of the

1

motor casing 6.

.Then assemble all the fittings reversing the order and direction in which they were dismantled. Please take care that the seal ring 5 is properly re-fitted.

➔ Make sure while assembling that you attach the pump casing with the pressure joint being cated, press it firmly and then turn it straight to the right.

➔Observe the markings.

Storage

Cleaning the filter tank

Filter tank and pump should be free from dirt particles!

How to clean:

.Disconnect the plug from the solar panel!

.Remove the pump from the water.

.If necessary remove the gravel.

.Clean the pump and the filter using a water jet.

.If there are deposits of dirt inside the pump then dismantle the casing (➔ see “Dismantling ”) and carefully clean the interior fittings with water.

Information: Do not use any hard objects or strong detergents!

Where to store A The pump should be stored out of the reach of children.

1. Remove the pump from the pond and store away from frost before the first frost sets in.

2. Clean and check the pump carefully.

3. Store the pump in a container filled with water. The mains plug must not be submerged.

Information

Blocked feed impeller

If the feed impeller becomes blocked, the pump and the filter should be cleaned (see above).

Complaints/Repairs

Product liability

If you have any problems with your Fountain Pump, please con- tact our Service or return the defective unit together with a short description of the problem – in case of guarantee, with the warranty card duly completed and signed – postage paid to one of the GARDENA Service Centres listed on the back of this leaflet.

We expressly point out that, in accordance with the product liability law, we are not liable for any damage caused by our units if it is due to improper repair or if parts exchanged are not original GARDENA parts or parts approved by us, and, if the repairs were not carried out by a GARDENA Service Centre or an authorised specialist. The same applies to spare parts and accessories.

14 15