Jensen CD-600 operating instructions Esp, Location of Controls, Power Sources

Output Power	20mW (32Ω)
Frequency Response	100 ~ 20000 Hz
Power Source	2 x DC 1.5V ‘AAA’ size (UM-4) batteries (not included) or
	AC-DC Adaptor, 4.5VDC ~ 500mA (not included)
ESP	60 seconds
Headphone Jack	Stereo 3.5mm jack plug
	LOCATION OF CONTROLS
Main Unit

1VOLUME UP button

2PLAY/PAUSE/POWER ON button

3SKIP/SEARCH UP button

4CD LID OPEN button

5LOCK switch for CD LID OPEN button

6STOP button

7SKIP/SEARCH DOWN button

8VOLUME DOWN button

9PROG button

10MODE button

11BBS switch

12HOLD switch

13DC jack

14PHONE jack

Remote Control		1
R1	VOLUME knob
R2	STOP button
R3	Headphone Jack
R4	PLAY/PAUSE button
R5	HOLD switch
R6	SKIP/SEARCH UP button
R7	SKIP/SEARCH DOWN button
R8	Belt/Lapel Clip

POWER SOURCES

This CD player operates on two 1.5VDC ‘AAA’ size (UM-4) alkaline batteries (not included) or with an AC-DC adaptor with an output of 4.5VDC~500mA (not included).

To install batteries into the player,

1.Press the CD LID OPEN button to open the CD lid.

2.Open the battery compartment cover located under the CD lid.

3.Insert the two 1.5VDC ‘AAA’ size (UM-4) alkaline batteries into the Battery Compartment following the polarity markings as indicated in the compartment.

CAUTION:

-Be sure that the batteries are installed correctly. Wrong polarity may damage the unit.

-Please remove the batteries from the unit if you do not plan to use the unit for several weeks.