I n p u t G a i n C o n t r o l
There is an Input Gain Control located on the end panel under the RCA input jacks. This is not a volume control! This control matches the output signal voltage of the source unit to the amplifier inputs.
By turning the control clockwise (to the right), the inputs of the amplifier become more sensitive and will allow a weak signal of approximately 1/2 volt to drive the amplifier to full power. At the same time, while an amplifier with its level control at maximum is able to drive a weak signal, it also picks up and amplifies any noises lurking in the background, such as a brake light pop, alternator whine, or ignition tick.
Increasing the signal voltage to the amplifier by using a high output source unit (or a TUBE DRIVER
S e t t i n g I n p u t G a i n
1.Set the Input Gain Control to just above the lowest setting.
2.Turn the master volume on the source unit or
3.With music playing, slowly increase each Input Gain Control until you hear distortion. Turn down the Gain Control until the distortion stops.
8