Safety and maintenance

•If you do not intend to use the clock radio for a long time, withdraw the power cord from the wall outlet.

•Place the set on a hard and ﬂat surface so that the system does not tilt.

•Where the MAINS plug or an appliance coupler is used as the disconnect device, the disconnect device shall remain readily operable.

•Install the unit near the AC outlet and where the AC power plug can be easily reached.

•The apparatus shall not be exposed to dripping or splashing

•Do not expose the set, batteries, to humidity, rain, sand or excessive heat caused by heating equipment or direct sunlight.

•No objects ﬁlled with liquids, such as vases, shall be placed on the apparatus.

•No naked ﬂame sources, such as lighted candles, should be placed on the apparatus.

•The apparatus shall not be exposed to dripping or splashing and that no objects ﬁlled with liquids, such as vases, shall be placed on the apparatus.

•Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type.

•Do not cover the set.Adequate ventilation with a minimum gap of 6 inches between the ventilation holes and surrounding surfaces is necessary to prevent heat build-up.

•The mechanical parts of the set contain self- lubricating bearings and must not be oiled or lubricated.

•To clean the set, use a soft dry cloth. Do not use any cleaning agents containing alcohol, ammonia, benzene or abrasives as these may harm the housing.