OPERATING INSTRUCTIONS
Daylight Saving Time (DST) ON/OFF Switch
IMPORTANT: The Daylight Saving Time (DST) ON/OFF switch is located on the left side panel. This switch was set to the “OFF” position at our factory prior to shipment. At the beginning of Daylight Saving Time set the DST switch to the “ON” position. The time will advance by one hour. At the end of Daylight Saving Time set the DST switch to the “OFF” position. The time will back up by one hour.
The first time you connect your new SmartSet® clock radio to the AC outlet the internal computer will automatically set the display to show the correct EASTERN STANDARD TIME. This is the initial default setting. The display will scan for few seconds and then show the correct Eastern Standard Time. If you are doing this during Daylight Saving Time, slide the DST ON/OFF switch, located on the left side panel, to the “ON” position. The display will then show the correct Eastern Daylight Time.
DST ON/OFF Switch
If you live in the Eastern Time zone, there’s nothing else to do. Your clock is set correctly and running. If you do not live in the Eastern Time zone you must change the default zone display to your own zone. You only do this one time and the SmartSet® will remember the new default zone setting and will always return to that setting after a power interruption.
8
CKS1701_032306.p65 | 8 |
23/3/2006, 14:44