Power Source, Power Failure Indicator

To install the battery:

•	Open the battery compartment cover on the bottom	Press
•	Open the battery compartment cover on the bottom
	of the radio by pressing the tab in the direction of
	the arrow.

• Connect the 9-volt battery to the battery terminal. It can only be connected one way.

• Push the battery into the battery compartment and replace the cover.

9 VOLT

POWER FAILURE INDICATOR

If no battery is installed in the radio, or if the battery in the compartment is weak or dead, the time and alarm settings will be lost if the power is interrupted. When the power is restored the clock display will begin flashing. This is your indication that the time display is incorrect and needs to be reset. Important: After you reset the time, be sure to reset your alarm settings as well.

POWER SOURCE

This radio is designed to operate on normal 110V-120V 60Hz AC power only. Do not attempt to operate the radio on any other power source. You could cause damage to the radio that is not covered by your warranty.

This radio should be connected to an AC outlet that is always ‘live’. Do not connect it to an outlet that is controlled by a wall switch. When the power to the radio is interrupted, the Sure Alarm battery back up system takes over to maintain the time and alarm settings. To maximize the life of the back up battery, keep the radio connected to a ‘live’ AC outlet at all times.

This radio uses a polarized AC plug which has one blade wider than the other. This plug will only fit into a polarized AC outlet. This is a safety feature. If the plug will not fit, you may have an older non-polarized AC outlet. Do not defeat the safety feature by trying to file the wider blade, or replacing the plug. Contact an electrician to replace your outdated outlet.