CKD9905 O/M.QXD 5/29/03 1:38 PM Page 6
INSTALLATION
Unravel the AC cord and connect it to a |
| ||
conveniently located AC outlet having |
| ||
| |||
120V and 60Hz only. The Clock Display |
| ||
will illuminate and “12:00” will appear in the |
| ||
display. |
|
| |
NOTE: If the AC plug does not fit into a |
|
| |
nonpolarized outlet, do not file or cut the |
|
| |
wide blade. |
|
|
|
If the AC cord is disconnected or if there is a power failure, this electronic clock is designed to continue operating internally (without showing the time on the Clock Display) with a 9 volt battery (not included). To install the battery, remove the battery compartment cover and connect the battery to the terminals of the battery snap inside the compartment (use of an alkaline battery is recommended) and install the battery compartment cover back into place.
9V
Be sure to check the condition of the battery periodically by disconnecting the AC cord and connecting it again two to three minutes later. The preset times should continue operating. If the present time resets to “12:00”, it indicates the battery is dead or not connected properly. A fresh 9 volt battery will keep the internal times accurately for approximately 40 hours continuously. If you experience only the normal brief interruptions of AC power, the battery can last much longer. It is recommended to install a new battery every eight to 12 months.
6