Excalibur electronic 187BK manual Remote Control Battery, Setting Up the iBlaster, Clock Radio

Figure 5: Clock Display			RADIO FREQUENCY/TIME ZONE INDICATOR
BATTERY LOW	TIME/ALARM
INDICATOR	DISPLAY	PM INDICATOR

DAYLIGHT	ALARM ARMED	SLEEP	AM/FM
	WAKE TO
SAVINGS TIME		INDICATOR	INDICATOR
	INDICATOR:	IPOD
	IPOD, RADIO,	INDICATOR

When installing batteries, be sure to not mix old and new bat- teries or mix alkaline, standard (carbon-zinc) or rechargeable batteries.

Figure 6:

Remote Control Battery

Your remote control requires one CR2032 3-volt lithium bat- tery (included). To replace the battery, press the tab on the base of the remote to the left to release the battery compartment, as shown in Figure 6. Pull it out like you would open a drawer. Insert the CR-2032 3-volt bat- tery, making sure to match the polarity (+ and -) with the dia- gram inside the battery compart- ment. Push it back, until it locks securely.

			BUZZER
Powering your iBlaster Clock Radio
You	power	your	iBlaster	towel or magazine. You'll find
Clock Radio by using an AC				the battery compartment on the
adaptor (included). To use the				unit's base.
AC adaptor, connect the AC				Press the side tab and lift to
adaptor to the DC jack located				release the lid of the battery
on the back of the unit. Plug the				compartment. Install two AA
AC adaptor into an electrical				batteries, making sure to match
outlet.	iBlaster	Clock Radio		the polarity (+ and -) with the
Your				diagram inside the battery com-
requires	two	AA	batteries	partment. Replace the lid by
(included) for the clock backup				pressing on the side tabs and
power. To install batteries, care-				returning it to its original posi-
fully turn it over so that the				tion. Release the side tabs once
iBlaster Clock Radio is upside				the lid is secure.
down on a soft surface, such as a				6

How to Use Your iBlaster Clock Radio
Setting Up the iBlaster			for approximately			two seconds
Clock Radio			until the Time Zone Indicator at
Your iBlaster Clock Radio is			the top right corner of the display
preset to Eastern Standard Time.			shows the current time zone. Turn
To change this setting, use the fol-			the Setting Knob to select the time
lowing instructions.		whether	zone.
Depending	on		ALS: Alaska
Daylight Savings Time (DST) is			HAI:	Hawaii
in effect, set the DST Switch			ATL:	Atlantic
located at the bottom of the unit to			EAS: Eastern
+1 or -1to activate this feature.			CEN: Central
Activating the	+1 switch will set		MTN: Mountain
the time forward by one hour.			AC: Pacific			ZONE Button
To change the time zone, press			Press	the	TIME
and hold the Time Zone Button			7 again to	exit	this	mode. You