iHome iH22 manual Listening to your iPod, Snooze Operation, Sure Alarm, Charging your iPod

Page 9

Using the iH22

Snooze Operation

1.Press and hold the Snooze/Dimmer Button for a few seconds to set snooze time. Press the or Button to set the snooze timer from 1 to 30 minutes.

2.Press the Snooze/Dimmer Button after the alarm sounds. The alarm will be silenced and come on again after the set snooze time. Snooze can be pressed several times during the 1 hour alarm cycle.

Sure Alarm

The iH22 has a sure alarm feature. If backup batteries are installed, the buzzer alarm will still sound in the event of power failure.

Charging your iPod

Note: Please make sure you are using the correct insert for your iPod (see Installing iPod Insert) and that the iPod is properly docked into the iH22. Failure to do so may damage your iPod.

1.While your iPod is docked in the unit and the unit is connected to AC power, it recharges (until fully charged). Back up batteries will NOT charge iPod. Note that non-docking iPod models will NOT charge.

Listening to your iPod

1.

Dock your already playing iPod. The iH22 will automatically turn on and you will hear the music playing from your iPod.

 

Note: If the volume on the playing track is too low, iH22 may not detect that your iPod is in play mode. If this happens,

 

press the

 

 

 

Button on the main unit to play it.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

2.

When the iPod is docked and in standby mode, press the

 

 

 

Button on the iH22 to play it. The

will appear on the

 

 

 

 

 

display, indicating iPod play mode.

 

 

 

3.Press the Button again to pause play; press again to resume it.

4.Press the Volume and Volume Button to adjust the system volume.

5.Press the or Button on the unit to go to the next or previous track. Press and hold while a track is playing for high speed forward or reverse music search of the current track.

6.To turn off the unit, press the Button. The iPod will continue charging while in the dock.

Listening to non-docking iPod or other portable audio devices

If you are using an iPod without a docking port or another MP3 player or portable audio device, you can play it through the iH22 via the MP3 Line-in Jack located on the back of the unit.

1.Plug one end of an audio patch cord (available at www.ihomeaudio.com) into the headphone or line-out jack on your device and the other end of the patch cord into the iH22 MP3 Line-in Jack.

2.Press the Button to turn the iH22 on.

3.Turn on and play your device.

4.Press the Volume and Volume Button to adjust the system volume. You may need to adjust your device volume, too.

5.To turn off the unit, press the Button. Please remember to turn off your device, too.

5

Image 9
Contents Dual Alarm Clock for your iPod Risk of Electric Shock Do not Open Consumer Guide to Product SafetyConsumer Guide to Product Safety FCC Information Table of ContentsTo purchase one Quick start Rear Panel Controls and IndicatorsInstalling iPod Insert Installing Clock Backup BatteriesBattery Low Indicator IH22 displaySetting Time and Calendar Using the iH22Using the Alarms Setting the AlarmsListening to your iPod Sure AlarmSnooze Operation Charging your iPodDimmer Operation Sleep OperationSymptom Possible Problem Solution Trouble ShootingConsumer Repair Department Limited 90-Day Warranty Information