GPX C253B warranty Introduction and Setup, PM Indicator, Alarm 1 Buzzer

USER’S GUIDE

V: 805-01

C253B Clock Radio with Dual Alarm

FCC Warnings

Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment

does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

•Reorient or relocate the receiving antenna.

•Increase the separation between the equipment and receiver.

•Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

•Consult the dealer or an experienced radio/TV technician for help.

Introduction and Setup

Power

Plug the included AC/DC power adapter into the DC POWER INPUT on the dock and an AC power outlet to power the dock.

Battery Backup

The battery backup is intended for short power outages only. The clock radio’s primary functions cannot run off of the battery backup alone.

Requires 2, AAA-size, batteries (not included)

PM Indicator	LED Display
Lights when the time is in
the PM.

LINE IN

Line Input

Dimmer Press to dim the display.

Tuning/Min/Hour Press to tune the radio.

Press to adjust the minute or hour when setting the clock or alarm.

Clock/Mem In Off mode, press and hold to begin setting the time.

In radio mode, press to cycle through preset stations.

Alarm 1 Buzzer/	Alarm 2 Buzzer/
Radio Indicator	Radio Indicator
Lights when the	Lights when the
alarm 1 is on and set	alarm 2 is on and set
to buzzer or radio.	to buzzer or radio.

Snooze/Sleep	Volume/AL1/AL2	Source/AL Off
Press to snooze the	Press to adjust the volume.	Press repeatedly to switch
alarm after it sounds.	Press to begin setting Alarm 1	between Line in, FM, or AM
In on mode, press	or Alarm 2. Note: Volume will	Radio modes. Press and
repeatedly to set the	not function in line in mode.	hold to turn off the radio.
sleep timer.		Press to turn off the alarm.

For Warranty Information and the most up-to-date version of this User’s Guide, go to www.gpx.com	Customer Service: 1-888-999-4215
Email Support: prodinfo@dpiinc.com, Email Parts: partsinfo@dpiinc.com

Copyright © 2013 Digital Products International (DPI, Inc.) All other trademarks appearing herein are the property of their respective owners. Specifications are subject to change without notice.