T1251 I/B_front Feb. 28, 07.
|
|
| Installation and Maintenance |
| |
|
|
|
|
| |
|
| Installation |
|
| |
| 1. | Remove the unit and all packing materials from the carton.You should save the packing | |||
|
|
| materials in case unit needs to be returned for service. If you do not wish to save the | ||
|
|
| materials, please dispose of them properly. |
|
|
| 2. | Place the unit on a stable, level surface, close to an AC outlet, out of direct sunlight, | |||
|
|
| and away from sources of dust, dirt, heat, water, moisture, vibration, and strong | ||
|
|
| magnetic fields. |
|
|
|
| "Sure Alarm" Battery Backup Installation |
|
| |
|
| The Battery Low Indicator flashes when there is not enough power to run the backup. | |||
|
| It is recommended that 3 “AA” batteries be installed into the unit, as directed below, to | |||
|
| activate the “Sure Alarm” battery backup feature. In the event that the AC power cord | |||
|
| is disconnected or a power failure or other interruption occurs, the “Sure Alarm” system | |||
|
| will maintain clock and alarm settings for the life of the batteries, ensuring that the alarm | |||
|
| will sound at the set time (Note: while operating on battery power, all set alarms will sound | |||
|
| as a buzzer). When power is restored, the clock will cease using battery power, and will | |||
|
| again operate on AC power. |
|
| |
| 1. | Use a Phillips screwdriver to remove the battery |
|
| |
|
|
| compartment door. |
|
|
|
|
|
|
| |
| 2. | Install 3 “AA” batteries (alkaline batteries are | 3 | 1 | |
|
|
| recommended for longer life) into the battery | ||
|
|
|
| ||
|
|
| compartment, making sure that the + and – polarities |
|
|
|
|
| match up with the diagram printed inside the |
| 2 |
|
|
| compartment. |
| |
|
|
|
|
| |
|
| Note: Do not replace batteries without AC plugged in, |
|
| |
|
| otherwise you will loose the clock settings. |
|
| |
| 3. | Close the battery compartment door and tighten the |
|
| |
|
|
| screw. Gently return the clock radio to its upright | Battery Compartment | |
|
|
| position. | ||
|
|
|
|
| |
|
| Maintenance |
|
| |
| 1. | Place the unit on a level surface away from sources of direct sunlight or excessive heat. | |||
| 2. | Protect your furniture when placing your unit on a natural wood and lacquered finish. | |||
|
|
| A cloth or other protective material should be placed between it and the furniture. | ||
| 3. | Clean your unit with a soft cloth moistened only with mild soap and water. Stronger | |||
|
|
| cleaning agents, such as Benzine, thinner or similar materials can mar the surface of | ||
|
|
| the case. |
|
|
| 4. | If the unit is not to be used for a prolonged period, such as a month or longer, remove | |||
|
|
| the batteries to prevent possible corrosion. Should the battery compartment become | ||
Printed in China | corroded or dirty, clean the compartment thoroughly and replace the batteries. | ||||
|
|
| |||
A Consumer Guide to Product Safety
IMPORTANT SAFETY INSTRUCTIONS
This unit has been designed and manufactured to assure your personal safety. Improper use can result in potential electrical shock or fire hazards. Please read all the safety and operating instructions carefully before installation and use. Keep these instructions handy for future reference. Take special note, adhere to all warning, and always follow the instructions on the unit and in the instructions and service manuals.
1.Water and Moisture - The unit should not be used near water. For example: near a bathtub, washbowl, kitchen sink, laundry tub, swimming pool or in a wet basement.
2.Ventilation - The unit should be situated so that its location or position does not interfere with its proper ventilation. For example, it should not be situated on a bed, sofa, rug or similar surface that may block ventilation openings. Also, it should not be placed in a built- in installation, such as a bookcase or cabinet that may impede the flow of air through the ventilation openings.
3.Heat - The unit should be situated away from heat sources such as radiators, heat registers, stoves or other appliances (including amplifiers) that produce heat.
4.Power Sources - The unit should be connected to a power supply only of the type described in the operating instructions or as marked on the appliance.
5.Grounding or Polarization - This product is equipped with a polarized alternating current line plug (a plug having one blade wider than the other). As a safety feature this plug will fit into the power outlet only one way. If you are unable to fit the plug fully into the outlet, try reversing the plug. If the plug still fails to fit, contact your electrician to replace your obsolete outlet. Do not defeat the safety purpose of the polarized plug.
6.
7.Cleaning - Unplug this product from the well outlet before cleaning. Do not use liquid cleaners or aerosol cleaners. Use a damp cloth for cleaning.
8.
9.Objects and Liquid Entry - Care should be taken so that objects do not fall and liquids are not spilled into the enclosure through openings.
10.Attachments - Do not use attachments not recommended by the product manufacturer as they may cause hazards.
11.Lightning - For added protection for this product during a lightning storm, or when it is left unattended and unused for long periods of time, unplug it from the wall outlet and disconnect the antenna or cable system. This will prevent damage to the product due to lightning and
12.Overloading - Do not overload wall outlets, extension cords, or integral convenience receptacles as this can result in a risk of fire or electric shock.
13.Damage Requiring Service - The unit should be serviced by qualified service personnel when:
A.The power supply cord or plug has been damaged.
B.Objects have fallen into or liquid has been spilled into the enclosure.
C.The unit has been exposed to rain.
D.The unit has been dropped or the enclosure damaged.
E.The unit does not appear to operate normally or exhibits a marked change in performance.
14.Servicing - The user should not attempt to service the unit beyond that described in the user’s operating instructions. All other servicing should be referred to qualified service personnel.
15.Safety Check - Upon completion of any service or repairs to this product, ask the service telchnician to perform safety checks to determine that the product is in proper operating condition.
16.Antenna - Do not connect to an external antenna.
FCC Information
This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
This equipment complies with the limits for a Class B digital device as specified in Part 15 of FCC Rules. These limits provide reasonable protection against radio and TV interference in a residential area.
However, your equipment might cause TV or radio interference even when it is operating properly. To eliminate interference you can try one or more of the following corrective measures:
• Reorient or relocate the receiving antenna.
• Increase the distance between the equipment and the radio or TV.
•Use outlets on different electrical circuits for the equipment and the radio or TV. Consult your dealer or an experienced radio/television technician if the problem still exists.
Modifying or tampering with your system’s internal components can cause a malfunction and might invalidate the system’s warranty and void your FCC authorization to operate it. If your system is not performing as it should, call SDI Technologies Inc., Timex Audio Products Consumer Services,
Laser Safety
This unit employs a laser. Only a qualified person should remove the cover or attempt to service this device, because of possible eye injury.
CAUTION: USE OF CONTROLS, ADJUSTMENTS OR PERFORMANCE OF PROCEDURES OTHER THAN SPECIFIED HEREIN MAY RESULT IN HAZARDOUS RADIATION EXPOSURE.
DANGER: INVISIBLE LASER RADIATION WHEN OPEN AND INTERLOCK FAILED OR DEFEATED, AVOID DIRECT EXPOSURE TO BEAM.
CAUTION: HAZARDOUS LASER RADIATION WHEN OPEN AND INTERLOCK DEFEATED.
CAUTION
RISK OF ELECTRIC SHOCK.
DO NOT OPEN
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO
WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.
The lightning flash with arrowhead in an equilateral triangle is intended to alert the user of the presence of uninsulated “dangerous voltage” within the product’s enclosure that may be of sufficient magnitude to constitute a risk of electric shock.
The exclamation point within an equilateral triangle is intended to alert the user of the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance.
The symbols above are located at the back of the cabinet.
CAUTION: To prevent electric shock, match wide blade of plug to wide slot. Fully insert.
ATTENTION: Pour éviter les choc électriques. Introduire la lame la plus large de la fiche dans la borne correspondante de la prises et pousser jusqu’au fond.
Note: The manufacturer is not responsible for any radio or TV interference cause by unauthorized modifications to this equipment. Such modification could void the user’s authority to operate the equipment.
Model T1251
Stereo CD
Clock Radio with
Auto-Set Digital Tuning
SNOOZE/DIMMER
For additional information, online registration, and exclusive special offers visit our website:
www.timexaudio.com
For questions or comments regarding this or other products, please call our
Para instruccionese en Espanol, llame al