Scott SCR120 owner manual Changing the Lithium Battery, Be Careful not to Lose These Small Screws

Page 18

CHANGING THE LITHIUM BATTERY

Like all batteries, eventually the built in lithium battery will need to be replaced. A number of factors, such as, the length of time between the date the radio was manufactured and the date you plugged it in for the first time determine the amount of time before replacement. During this initial storage period, the lithium battery is supplying power to the E-Z Set computer memory. Once you plug the radio in, your household outlet supplies the power, and the battery is not being used. A fresh lithium battery can supply power to the E-Z Set computer for at least 3 years even if it is never connected to an AC power supply. If your radio was connected to your AC supply within a few months after it was manufactured, and you experience only the normal, nuisance type, short duration power interruptions, your battery may last for up to 5 years or even longer.

When the battery power drops below a certain level, the BATT. LOW indicator will ‘flash’. When you see this indicator, you should change the battery as soon as it is convenient for you to do so. To change the battery proceed as follows:

1.) Purchase a replacement 3V lithium battery wherever batteries are sold. The battery type is CR2430 or equivalent.

2.) Remove the battery from its package so it is ready to install.

IMPORTANT: Leave the radio power cord connected to your AC outlet. This will provide power to the E-Z Set computer memory while the original lithium battery is removed.

3.) Use a small screwdriver to remove the two small screws securing the battery holder on the back cabinet.

BE CAREFUL NOT TO LOSE THESE SMALL SCREWS!

4.) Remove the battery holder from the cabinet. Then remove the original battery from the holder and insert the new battery into the holder the same way.

5.) Slide the holder with the new battery back into the opening in the cabinet.

6.) Replace the two screws that secure the battery holder in the cabinet, and confirm that the BATT. LOW indicator is ‘Off’.

7.) Save these instructions. You’ll have to do this again five to eight years from now!

17

SCR120_080206.p65

17

2/8/2006, 15:56

Image 18
Contents SCR120 Important Safety Instructions Congratulations Important Notes FCC InformationUnpacking and SET UP Preparation for USEProtect Your Furniture Power Source Location of Controls and Indicators RAD/BUZ/OFF Setting the TIME, the First Time Operating InstructionsDaylight Saving and Leap Year Adjustments Date DisplayYear Display Important Daylight Saving Time Information Manual Time Adjustments Adjusting the Wake UP TimesSelecting the Alarm Mode Checking the Wake UP Times and Alarm ModeListening to the Radio Antenna InformationWake to Radio Snooze Alarm Wake to BuzzerRadio and Buzzer Operation Sleep to Music Timer Dimmer ControlChanging the Lithium Battery Be Careful not to Lose These Small ScrewsResetting the Clock After a Total Memory Loss Initial default setting is AM 1200, Saturday, January 1st 1Important Note Care and Maintenance Lithium Battery PrecautionsCare of Cabinets SCOTT, INC Clock Radio Limited Warranty SCOTT, INC