Instructions, Installation, Operation

INSTRUCTIONS

The Skull ALARM CLOCK WITH Bone Crusher

MODEL SBS550BC

Please retain the instruction manual for future reference.

Features show on diagram above:		8.	Flashing Light Display	15.	Bone Crusher Output
1.	Alarm Indicator	8.	Flashing Light Display	15.	Bone Crusher Output
2.	PM Indicator	9.	Tone Control Knob	16.	AUX Line-in Jack
3.	Alarm Function Switch	10.	Alarm Set	17.	AC Adaptor
4.	Dimmer Switch	11.	Hour Button	18.	Battery Compartment
5.	Skull Snooze button	12.	Minute Button	19.	Hour Format & Power
6.	Skull LED Light	13.	Time Set Button		Cycle
7.	Volume Knob	14.	Alarm Off Button

INSTALLATION

AC 9V Power Input

Attach the AC power supply input to the side of clock at AC9V IN (17) next to the VIBRATOR input (15), smaller input of the two. Important: do not confuse AC input with vibrator input. The eyes of the skull will light up continuously when it is connected to the power source.

Bone Crusher / Vibrator – Figure B

1)Attach the bed shaker jack to the back of the clock at VIBRATOR input (15).

2)Place Bone Crusher under mattress (best) or pillow.

Battery Backup

To use the battery backup, you can install a 9-volt alkaline battery in the back of the clock located under the battery cover (18). Note the LED display will not light up during power failure but the clock will still be running and keeping proper time until the power is restored.

NOTE: For the best results it is recommended that the battery be changed every 6-8 months. If the clock is not used for a while, it is recommended to remove the battery to aviod leakage.

OPERATION

Setting the correct time

1)Press and hold the Time Button (13) at the same time press the Hour Button (11) to advance the clock display rapidly until the hour is correct; press the Minute Button (12) to advance the clock display rapidly until the hour is correct.

2)A lighted dot (2) in the upper left of the clock display indicated the time is PM. For AM time indication, the dot (2) does not light up.

Setting the alarm time

1)Simply follow the instructions mentioned under “Setting the correct time“ except that you will have to press the Alarm Set Button (10) instead of the TIME Button.