Accton Technology EN1407-SX manual Adapter Installation Problems, Network Connection Problems

Page 15

Cheetah Gigabit Adapter

Adapter Installation Problems

If your computer can’t find the Cheetah Gigabit Adapter or the network driver doesn’t install correctly, check the following:

Make sure the adapter is securely seated in the PCI slot. Check for any hardware problems, such as physical damage to the card’s edge connector.

Try the card in another PCI busmaster slot. If all fails, test with another Cheetah Gigabit Adapter that is known to operate correctly.

Check for resource conflict in the PCI configuration. See “PCI Compatibility.”

Make sure your computer is using the latest BIOS available.

If there are other network adapters in the computer, they may be causing conflict. Remove all other adapters from the computer and test the Accton adapter separately.

Check for a defective computer or PCI bus by trying the adapter in another computer that is known to operate correctly.

Network Connection Problems

If the Link LED on the adapter’s bracket does not light, or if you can’t access any network resources from the computer. Check the following:

Check the rating of the fiber cable and make sure its length is within the IEEE 802.3z 1000BASE-SX requirements.

Inspect all network cables and connections. Make sure the cable is securely attached to the adapter’s connector.

Make sure the correct software driver is installed for your operating system. If necessary, try reinstalling the driver.

Make sure the computer and other network devices are receiving power.

Make sure the adapter is connected to a Gigabit Ethernet switch or buffered repeater port that is configured for Auto- Negotiation. If the card’s duplex mode has been configured manually, check that it matches that of the network device port.

The network device port that the adapter is attached to may be defective. Try using another port on the device.

If you cannot access a Windows or NetWare service on the network, check that you have enabled and configured the service correctly. If you cannot connect to a particular server, be sure that you have access rights and a valid ID and password.

If you cannot access the Internet, be sure you have configured your system for TCP/IP.

15

Image 15
Contents Cheetah Gigabit Adapter Quick Installation Guide Page Package Checklist IntroductionHardware Description System Requirements LED IndicatorsInstallation Driver Installation and Configuration Connecting Fiber Cable How to Run the Windows NT Utility Configuration and Diagnostic UtilityLocally Administered Network Address Network Card InformationAdvanced Properties Packet Propulsion Link ParametersJumbo Frame Support Vlan PropertiesUsing VLANs VLANTable MaintenanceTraffic Priority Vlan Capabilities Network Card DiagnosticsSend and Receive Test Local TestsPCI Compatibility TroubleshootingNetwork Connection Problems Adapter Installation ProblemsCSA Statement Canada CompliancesWarnhinweis Faseroptikanschlüsse Optische Sicherheit Class I Laser Safety ComplianceSpecifications General SpecificationsSoftware Drivers Page Disclaimer WarrantyCopyright Trademarks