RCA RC142 user manual FCC Information, Before you begin, General controls

Page 2

IMPORTANT SAFETY INSTRUCTIONS

PLEASE READ AND SAVE THIS FOR FUTURE REFERENCE

FCC Information

• Connect the equipment into an outlet on a circuit

Before you begin

Power failure indicator

unused for long periods of time.

Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged in any way, such as power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped.

ADDITIONAL SAFETY INFORMATION

The AC/DC adapter supplied with this product is intended to be correctly oriented in a vertical or floor mount position.

Do not use unauthorized chargers or power adapters. Use only chargers or power adapters that came with your product or that is listed in the user’s guide.

Apparatus shall not be exposed to dripping or splashing and no objects filled with liquids, such as vases, shall be placed on the apparatus.

Always leave sufficient space around the product for ventilation. Do not place product in or on a bed, rug, in a bookcase or cabinet that may prevent air flow through vent openings.

Do not place lighted candles, cigarettes, cigars, etc. on the product.

Care should be taken so that objects do not fall into the product.

Do not attempt to disassemble the cabinet. This product does not contain customer serviceable components.

The marking information is located at the bottom of apparatus.

To be completely disconnect the power input, the AC/ DC adaptor of apparatus shall be disconnected from the mains.

AC/DC adaptor is a disconnect device. The AC/DC adaptor should not be obstructed OR should be easily accessed during intended use.

The ventilation should not be impeded by covering the ventilation openings with items such as newspaper, table-cloths, curtains etc.

No naked flame sources such as lighted candled should be placed on the apparatus.

Attention should be drawn to the environmental aspects of battery disposal.

The use of apparatus in moderate climates.

Important battery precautions

Any battery may present a risk of fire, explosion, or chemical burn if abused. Do not try to charge a battery that is not intended to be recharged, do not incinerate,

and do not puncture.

Non-rechargeable batteries, such as alkaline batteries, may leak if left in your product for a long period of time. Remove the batteries from the product if you are not going to use it for a month or more.

If your product uses more than one battery, do not mix types and make sure they are inserted correctly. Mixing types or inserting incorrectly may cause them to leak.

Discard any leaky or deformed battery immediately. They may cause skin burns or other personal injury.

Please help to protect the environment by recycling or disposing of batteries according to federal, state, and local regulations.

WARNING: The battery (battery or batteries or battery pack) shall not be exposed to excessive heat such as sunshine, fire or the like.

Ecology

Help protect the environment - we recommend that you dispose of used batteries by putting them into specially designed receptacles.

Electrical power information

AC/DC Adaptor:

Input: 100 - 240 V ~ AC 50/60 Hz

Output: 5.0 V---DC 1.2A

FCC Information

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to

Part 15 of FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

different from that to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician

for help.

Changes or modifications not expressly approved by VOXX Accessories Corporation could void the user’s authority to operate the equipment.

Industry Canada Regulatory Information

CAN ICES-3 (B)/NMB-3 (B)

Avis d’Industrie Canada

CAN ICES-3 (B)/NMB-3 (B)

Before you begin

Plugging in for power

Connect the supplied power adaptor to the unit’s Power jack, and connect the other end to a convenient wall outlet.

Once connected with power, the clock flashes. Refer to the Clock section for instructions on properly setting the Clock.

Battery back-up operation

This clock radio is equipped with a timekeeping system that can be powered with two AA batteries (not included). The power failure protection circuit will not operate unless the batteries are installed.

When normal household power is interrupted or AC/ DC adaptor is unplugged, the battery will power the clock radio to keep track of time and alarm settings programmed into memory.

When the battery backup functions, the digital display will not light, however, the alarm will still sound during power interruption if the remaining battery power is adequate.

Normal operation will resume after AC power is restored so you will not have to reset the time or the alarm.

To install the battery:

1.Remove battery compartment door (located at the bottom of the radio) by applying thumb pressure to the tab on battery door and then lift the door out and off the cabinet.

2.Connect two AA batteries (not included) to the connector plug.

3.Replace the compartment door.

If you have not installed the two AA batteries in the product, or the batteries run out while AC/DC adaptor is disconnected, all the settings (clock and alarm) will be lost. After AC/

DC adaptor is reconnected, the Digital Display will flash to indicate that power was interrupted and you should readjust the time settings.

Alkaline (1.5V) battery is recommended. Carbon-zinc battery may be used but memory holding time will be substantially reduced. Memory holding time for a fresh alkaline battery is approximately 8 hours (if alarm is not operated) which should take care of short, nuisance-type AC power failures. To preserve battery life, the unit should remain plugged into an AC outlet. As the battery gets older, its voltage drops and memory may be lost. Be sure to replace the battery periodically. Battery should be removed if the unit will be stored for more than one month. A leaky battery can badly damage the clock radio.

General controls

Back view

USB – To charge your cell phone or other USB powered electronic devices

DC IN – Plug in for power

Image 2
Contents Enregistrement produit et remplissez le court questionnaire RC142Enregistrement du produit General controls FCC InformationBefore you begin Radio Alarm functionClock Sleep functionBrightness control Warranty informationAuxiliary source USB charging

RC142 specifications

The RCA RC142 is a remarkable piece of technology that symbolizes the pioneering spirit of RCA, a company known for its rich history in electronics and broadcasting. This innovative device is designed to enhance the entertainment experience for users by offering a perfect blend of functionality and modern features.

One of the standout characteristics of the RCA RC142 is its user-friendly design. The device features an intuitive interface that allows users to navigate through its various functions effortlessly. This ensures that even those who may not be tech-savvy can utilize its full potential without feeling overwhelmed. The sleek design complements modern aesthetics, making it a stylish addition to any home entertainment setup.

The RCA RC142 is equipped with advanced audio technology. With high-definition sound output, it delivers crisp and clear audio, making every viewing experience more immersive. The device incorporates surround sound capabilities, allowing users to feel as though they are part of the action. This feature is particularly appreciated during movie nights or when streaming music, as it enhances the overall atmosphere.

In addition to its impressive audio capabilities, the RCA RC142 integrates cutting-edge wireless technology. This allows users to connect seamlessly to various devices, including smartphones, tablets, and computers. The device supports Bluetooth connectivity, enabling users to stream their favorite music or podcasts directly from their devices without the hassle of tangled wires.

Moreover, the RCA RC142 is designed with versatility in mind. It includes multiple input options, ensuring compatibility with a wide variety of devices. This flexibility makes it an ideal choice for users who have several gadgets they wish to connect, ranging from gaming consoles to streaming devices and even traditional cable boxes.

Energy efficiency is another hallmark of the RCA RC142. With its eco-friendly design, the device consumes minimal power without compromising performance. This characteristic appeals to environmentally conscious consumers who seek to reduce their carbon footprint while enjoying high-quality entertainment.

In conclusion, the RCA RC142 stands out as an impressive device that combines advanced audio technology, user-friendly design, and versatile connectivity options. Its energy-efficient attributes further enhance its appeal, making it a perfect choice for anyone seeking to elevate their entertainment experience. RCA continues to uphold its tradition of innovation and quality with the RC142, celebrating a legacy that has shaped the world of electronics.