Quick-Start Guide

XDVD181 OPERATION

Inserting a Disc

Power On

Playback Start

Playback Stop

Power Off

Automatic Power Off

Using the Remote Control

Slide the OPEN button to the left and gently lift the lid.

The lid opens to a maximum 90 degrees. Do not open it any further - as severe damage may occur.

Align the center of the disc with the center of the spindle guide. Press gently down on the center of the disc to snap it into place, then gently close the lid until a click is heard.

Press the POWER button on the main unit for more than 2 seconds to turn the unit on.

Press the PLAY button. In general, the DVD will start playing automatically when the power is turned on. The DVD player will immediately start rendering the DVD program.

“ “ may appear on the display during operation.

“ “ means that feature or operation is not permitted by the DVD video player at this time.

Press the STOP button momentarily. The unit will return to the start-up logo.

When the unit is on, press POWER for more than 2 seconds to turn the unit off.

The unit will automatically enter screen saver mode (if activated) after approximately 3-1/2 minutes of no activity. The unit will also automatically power off after approximately 10 minutes of no activity.

Note:

The unit will resume playback from the beginning of the DVD when POWER is turned on.

Remove the clear plastic separator from the battery compartment before using the remote control. When replacing the battery, use only a 3 volt Lithium CR2025 or equivalent.

Point the remote at the IR sensor located on the front of the main unit. The operating distance is up to 20’ away from the main unit within 60° of the IR sensor.