General Operation Advanced Operation, Play modes

RD1021/1071 IB-EN 7/21/03 9:54 AM Page 14

General Operation

Advanced Operation

DSP

•Press repeatedly to select among the DSP modes:

FLAT > BASS > POP > ROCK > JAZZ

•During playback, press and hold DSP will show song title, artist, format and bit rate on display.

Play modes

•Press MODE repeatedly during play- back to switch among the following

playback modes:

Normal playback > Repeat All >

Shuffle	> Shuffle repeat	>
Program	P > Repeat program	P >
Normal playback

Note: Program and Repeat program will only appears if there are programmed tracks.

Programming Tracks

1.Press and hold MODE for 2 seconds in stop mode to enter program mode. You will see ‘P’ icon lit representing program mode, flashing ‘ - -’ for track selection and ‘P01’ for program list position. (If you have program in your player, the pre- programmed track number will be shown.

2.Press Skip backward or Skip for- ward to select a track. Selected track number will flash.

Note: The player will enter Intro Play mode and play the beginning of each track as you scroll through tracks for pro- gramming.

3.Press MODE to confirm selection.

4.Press MODE again to skip to the next programming position.

5.Repeat steps 2-4 for further selections. Maximum 20 selections can be made.

6.Press STOP to exit programming mode or unit returns to stop mode automatical- ly after 30 seconds if there is no key acti- vation.

See section on “Play Modes” to playback programmed tracks.

Editing program

Overwriting Programmed Tracks

1.In stop mode, press and hold MODE to enter program mode.

2.Press MODE to select the pro- grammed track you want to overwrite.

3.Press Skip backward or Skip for- ward to select the new track you want to store.

4.Press MODE to confirm selection.

5.Repeat steps 2 and 3 to overwrite additional programmed tracks.

Deleting Programmed Tracks

1.In stop mode, press and hold MODE to enter program mode.

2.Press MODE to select the pro- grammed track to be deleted.

3.Press and hold DSP for about 3 sec- onds to delete unwanted track from your program list, ‘ - - ‘ will show on dis- play to indicate successful deletion.

4.Repeat steps 2 and 3 to delete addi- tional tracks from the program list.

5.To cancel editing program, press STOP once , or unit will return to stop mode automatically after 30 seconds if there is no key activation.

File Download

When the unit is connected to the com-

puter, press PLAY to activate, then “USB EN Connected” will be displayed on the

screen.

During transfer, “USB Transfer ...” will flash. When the transfer is complete, the display will change to "USB Connected". Do not unplug the USB cable when the display is flashing.

NOTE:

See Software Instruction Manual for instructions to install USB driver , music management software and to transfer tracks to player and/or memory card.