MAINTENANCE | ||
|
|
|
15.Slide the insulating tube over the cable and torch head connections to the back of the torch head and align the holes in the insulating tube with the holes in the torch head.
16.Slide the barrel over the insulating tube, aligning the holes in the barrel with the holes in the insulat- ing tube. Secure the barrel and tube in place with the set screws and tighten with a 5/64" Allen wrench.
17.Slide the strain relief with the cable boot into the barrel. Do not allow the boot to slip out from under- neath the fingers of the strain relief. Align the holes in the strain relief with the holes in the barrel. Secure the barrel to the strain relief with the sock- et head cap screws and tighten with a 9/64" Allen wrench.
18.Tighten the strain relief cap hand tight and then tighten an additional
19.Place the hose clamp around the boot. Assemble the hose clamp such that it is snug around the boot.
20. Restore power to the machine.
PLASMA TORCH