Lincoln Electric IM666-A manual Mounting the Torch

Page 13

A-6	INSTALLATION	A-6

MOUNTING THE TORCH

Always insulate the torch from any equipment or fixturing. Use M19190 Bracket Arm to Torch Body Insulator if necessary. (See Figure 4, Torch mounting dimensions)

Check to make sure the cables are free to flex and do not get tangled or caught on other equipment. Do not let the cables drag on moving or hot parts.

Use a collision sensor if there is a risk that the torch may impact an object when the torch or work piece moves.

The case of the torch has holes drilled on the back, left and right sides for mounting the insulator on either the back or side of the torch. All of the holes are drilled and tapped for #10-24x.50 screws.

FIGURE 4

Torch Mounting Dimensions

M19190

TANDEM MIG TORCH

Image 13

Contents Tandem MIG Torch California Proposition 65 Warnings SafetyElectric Shock can kill Cylinder may explode if damaged Sûreté Pour Soudage a L’Arc Précautions DE SûretéThank You Table of Contents Technical Specifications Tandem MIG Torch InstallationDesign Summary General DescriptionCable Assembly Contact TIP and GAS Nozzle Installation Liner Installation Trimming InstructionsConnecting the Torch to the Welding Equipment Water Cooling Equipment Water Cooling EquipmentMounting the Torch Work Lead Wire StraightenersSeam Tracking Welding with Multiple Tandem MIG SystemsOperation Avoiding Wire Feeding ProblemsElectrodes and Equipment Making a WeldGeneral Options Accessories AccessoriesSafety Precautions MaintenanceMaintenance Torch Shield ReplacementLiner Replacement Contact TIP ReplacementHOW to USE Troubleshooting Guide TroubleshootingAir. Check for obstructions. Replace Work stud of each power source to Tandem MIG Torch Precaucion Warnung