COUGAR™ Push Pull Gun
Troubleshooting Guide
TESTING THE TORCH
Motor Check. | Remove the torch connector from the cabinet. | |
| Using the torch Control Cable Connector, check the resistance across pins “A” | |
| and “B” (motor leads). The resistance across the motor should be between | |
| ohms. If an open circuit or short exist, check the motor leads and motor | |
| independently. | |
|
|
|
Testing the Potentiometer. | Using the torch Control Cable Connector, check the resistance across pin “D” | |
| (wiper) and pin “C”. The resistance should vary from 5K - 0 ohms. | |
| Check the resistance across pin “D” (wiper) and pin “G”. The resistance should | |
| vary from 5K - 0 ohms. | |
|
|
|
Testing the Trigger Switch. | Using the torch Control Cable Connector, check for continuity across pins “E” | |
| and “F” when the trigger is pressed. | |
|
|
|
|
|
|
|
|
|
10