2.2.3 SHROUD
1.Remove the fan. (Refer to section 2.2.2)
2.Remove the shroud. (See Fig. 9)
3.
2.3 ELECTRICAL PARTS
2.3.1 MOTOR
1. Remove the cabinet. (Refer to section 2.1.2)
2. Remove the clamp cord and disconnect the wireFigure 9 housing in control box. (Refer to section 2.1.3)
3.Remove the turbo fan. (Refer to section 2.2.2)
4.Remove the fan. (Refer to section 2.2.2)
5.Remove the 4 or 2 screws which fasten the motor. (See Fig. 10)
6.Remove the motor.
7.
2.3.2 COMPRESSOR
1.Remove the cabinet. (Refer to section 2.1.2)
2.Discharge the refrigerant system using a FreonTM Recovery System.
Install a valve for recovery before venting the Freon. Remove the valve when finished.
3.Disconnect the 3 leads from the compressor.
4.After purging the unit completely, unbraze the suction and discharge tubes at the compressor connections.
5.Remove the 3 nuts and the 3 washers which fasten the compressor. (See Fig. 11)
6.Remove the compressor.
7.
2.3.3 CAPACITOR
1.Remove the control box. (Refer to section 2.1.3)
2.Remove the 1 screw
3.Open the control box
4.Disconnect all the leads on the capacitor terminals.
5.
Figure 10
Figure 11
Figure 12