Friedrich CP05C10 manual Complaint Cause Remedy

COMPLAINT	CAUSE	REMEDY
Fan motor noise.	Fan blade	If cracked, out of balance, or partially missing,
		replace it.
	Blower wheel	If cracked, out of balance, or partially missing,
		replace it.
	Loose set screw	Tighten it.
	Worn bearings	If knocking sounds continue when running
		replace the motor. If the motor hums or
		noise appears to be internal while running,
		replace motor.
Compressor will not run,	Voltage	Check voltage. See the limits on the preceding
fan motor runs.		page. If not within limits, call an electrician.
	Wiring	Check the wire connections; if loose, repair or
		replace the terminal. If the wires are discon-
		nected, refer to wiring diagram for identification,
		and replace the wires. Check the wire connections;
		If not according to the wiring diagram, correct
		the connections.
	Thermistor	Check the TEMP control. If not at the lowest
		number, set TEMP control to this setting.
		Check the continuity of the thermistor. Replace
		the control board if the circuit is open.
	Capacitor (discharge	Check the capacitor.
	capacitor before	Replace if not within ±10% of manufacturer’s
	servicing.)	rating, replace if shorted, open, or damaged.
	Compressor	Check the compressor for open circuit or
		ground. If open or grounded, replace the
		compressor.
	Overload	Check the compressor overload if externally mounted.
		Replace if open. (If the compressor temperature is
		high, remove the overload, cool, and retest.)
Compressor cycles on	Voltage	Check the voltage. See the limits on the
overload.		preceding page. If voltage is not within these limits,
		call an electrician.
	Overload	Check overload, if externally mounted.
		Replace if open. (If the compressor temperature
		is high, remove the overload, cool, and retest.)

—17 —