| MAINTENANCE |
| ||
|
|
|
|
|
REMOVAL, INSTALLATION AND TRIMMING INSTRUCTIONS FOR MAGNUM® LINERS FEEDING STEEL WIRE
(KP1933, KP1936 and KP1955 series liners)
NOTE: The variation in cable lengths prevents the interchangeability of liners. Once a liner has been cut for a particular gun, it should not be installed in anoth- er gun, unless it can meet the liner cut off length requirement. Liners are shipped with the jacket of the liner extended the proper amount.
a.Lay the gun and cable straight on a flat surface.
b.Remove and save the gas nozzle and nozzle insu- lator. Make sure that the set screw in the gas dif- fuser is backed out so as not to damage the liner. Use the 5/64” (2.0 mm) Allen wrench provided. Remove and save the gas diffuser from the end of the gun tube assembly. Remove and save the liner nut from connector end.
c.Remove old liner and insert a new untrimmed liner into the connector end of the cable. Be sure the liner bushing is stenciled appropriately for the wire size being used.
LINER ASSEMBLY (LINER BUSHING
TO BE TIGHTLY SEATED)
LINER NUT
d.Before installing the gas diffuser, fully seat the liner bushing in the connector end and install the liner nut and finger tighten.
e.Be sure the cable is straight and then trim the liner to the length shown in Figure E.1 (a gauge is includ- ed on the wrench provided with the connection kit for gauging the
f.Screw the gas diffuser onto the end of the gun tube and tighten with the wrench provided.
g.Tighten the set screw in the side of the gas diffuser against the cable liner using the Allen wrench pro- vided.
CAUTION
This screw should only be gently tightened. Overtightening will split or collapse the liner and cause poor wire feeding.
h. Replace the nozzle insulator and gas nozzle.
LINER TRIM
LENGTH
9/16" (14.3 mm)
GAS DIFFUSER
NOZZLE INSULATOR
GAS NOZZLE
Figure E.1
INSTALLATION AND TRIMMING INSTRUCTIONS FOR MAGNUM® LINERS FEEDING ALUMINUM WIRE
(KP1958 series liners)
1.Lay the gun out straight on a flat surface and remove the gas nozzle and nozzle insulator.
A.Remove the liner nut from the connector end of the cable.
B.Back out the set screw in the diffuser for guns that have a set screw in the diffuser.
2.Remove the liner and insert a new untrimmed liner into the connector end of the cable. Check that the coils of the spring liner can be seen through the holes in the gas diffuser.
3.Mark the liner 3/16" (5 mm) from the end of the liner guide. Pull the liner partially out and cut off the liner at the mark using a sharp knife.
4.Screw the brass liner nipple onto the liner and fully seat the liner busing into the liner guide.
A.Replace the liner nut and finger tighten.
5.For guns with a diffuser set screw, tighten the set screw in the side of the gas diffuser against the cable liner using the Allen wrench provided.
MAGNUM®