Making the connections
Connect the AC power supply cord only after all the other connections have been made.
32 1
To household AC outlet
1 Connect the FM indoor antenna.
Place the antenna where reception is best.
• Use an FM outdoor antenna if radio reception is poor.
Tape
(not supplied)
| 2 Connect the speakers. |
|
|
| Black | Red | Red |
| Cable with a |
|
|
| red line |
|
|
|
|
| Black |
| Be careful not to cross | ||
| the polarity of the speaker wires as doing so may | ||
| damage the speakers. |
|
|
| • Connect the cable with a red line to the red terminal (r). | ||
VQT5J68 | 3 Connect the AC power supply cord. |
| |
Do not use an AC power supply cord with other |
equipment.
Conserving power
4 The system consumes approximately 0.2 W when it is in standby mode. Disconnect the power supply if you do not use the system. Some settings will be lost after you disconnect the system. You have to set them again.
Connecting other equipment
You can connect a VCR, DVD player etc.
DVD player (not supplied)
Rear panel of this main unit
Audio cable (not supplied)
Note:
•Disconnect the AC power supply cord before connection.
•Switch off all equipment and read the appropriate operating instructions.
•Components and cables are sold separately.
•If you want to connect equipment other than those described, refer to the audio dealer.
•Sound distortion can occur when you use an adaptor.
•For information on the connection of a LAN cable, refer to page 6.
Placement of speakers
Tweeter
Place the speakers so that the tweeter is on the inner side. To prevent damage to the speakers, do not touch the speaker cones if you remove the nets.
Use only the supplied speakers.
The combination of the main unit and speakers give the best sound. You can cause damage to the system and decrease the sound quality if you use other speakers.
Note:
•Keep your speakers more than 10 mm (13/32 q) from the main unit for ventilation.
•Put the speakers on a flat safe surface.
•These speakers do not have magnetic shielding. Do not put them near TVs, PCs or other equipment easily influenced by magnetism.
•When you play at high levels for a long period, it can cause damage to the system and decrease the life of the system.
•Decrease the volume in these conditions to prevent damage:
-When you play distorted sound.
-When you adjust the sound quality.
CAUTION!
•Use the speakers only with the recommended system. If not, you can cause damage to the amplifier and speakers and can cause a fire. Consult an approved service personnel if damage occurs or if there is a sudden apparent change in performance.
•Do the procedures included in these instructions when you attach the speakers.