4.Read all instructions and warnings on any 12 volt DC battery before connecting the Charge Regulator to a battery.
5.Do not expose the Charge Regulator to rain or wet conditions.
6.Always unplug the Charge Regulator from its power source before performing any inspection, maintenance, or cleaning procedures.
7.Use caution not to short circuit and/or reverse the polarity of the load, solar panel, or battery.
8.Keep the Charge Regulator in a cool, ventilated location.
9.Repairs should be carried out only by a qualified technician.
10.The warnings, precautions, and instructions discussed in this instruction manual cannot cover all possible conditions and situations that may occur. It must be understood by the operator that common sense and caution are factors which cannot be built into this product, but must be supplied by the operator.
Save these instructions.
|
| Specifications | |
|
|
|
|
| Electrical | Power Input: Solar Panel / 22 VDC, 7 AMP, 100 Watt Maximum |
|
| Requirements | Power Output: 12 VDC Battery |
|
| Automatic |
|
|
| 14V (+0.5V) |
| |
| Protection |
|
|
| Automatic |
|
|
| Discharge | 10.5V (+0.5V) |
|
| Protection |
|
|
| Operating | 14º Fahrenheit to 108º Fahrenheit |
|
| Temperature |
| |
|
|
| |
| LED Indicators | Green = High Voltage / Yellow = Charging / Red = Low Voltage |
|
|
|
| |
| Connectors |
| |
| 3” Pigtail = Load |
| |
|
|
| |
|
|
|
|
SKU 96728 | For technical questions, please call | Page 4 |