Using the Battery Charger (DT-9721CHGE)
The Battery Charger can be used to charge the battery pack
1.
2.
Connect the power cable to the Battery Charger, and then plug the cable into an electrical outlet.
Attach the battery back by sliding in the direction indicated by the arrow. The CHARGE indicator lamp (orange) lights after a few seconds and charging begins. Charging is completed when the CHARGE indicator lamp goes out.
• Charging normally takes about 3 hours(when recharging the battery pack after it has been completely discharged).
•Charging time may vary depending on the ambient temperature and condition of the battery pack.
•The CHARGE indicator lamp lights once when a battery pack has been attached that has already been charged.
Important!
•Securely attach the battery pack to the Battery Charger.
•Charge the battery pack in a location that is free of vibrations.
•If the CHARGE indicator lamp does not light at all or does flash when a battery pack has been attached, this indicates the possibility of a malfunction either in the Battery Charger or battery pack. Please contact the store where you purchased the product or an authorized CASIO service provider.
•Only use the power cable provided with the Battery Charger (included).
•The following power cables must be used according to safety standards in the USA and Canada in particular. The power cable included with the Battery Charger satisfies the following criteria.
For USA and Canada
Use only CSA/UL Certified power supply cord set. Polarized Type, Type
For other countries
Must comply with requirements set out by the Safety Approval/Certification Organization in each country of use.
DT9721CHGE_E_P06_08.p65 | 6 | 2004.9.7, 2:48 PM |