Craftsman 15206 manual Buon

OPERATING BRAD NAILER

Always disconnect the tool from

the air supply before loading. When loading the

tool always aim the tool away from yourself and others. Make sure that the trigger is not pressed

while the tool is being loaded.

1.Press the magazine release button and slide open the magazine. (See Fig. F)

2.Insert a strip of fasteners. Strip should lay flat against magazine wall with heads resting on magazine ribbing and fastener points at bottom

of magazine. Strip should slide freely. (See Fig. G) 3.Push magazine closed and secure with release button. (See Fig. H)

4.Connect the tool to the air supply. Make sure the air supply is in the correct PSI range (see Operating Instructions).

5.Contact surface of workplace with tip of nailer. Depress the trigger to drive fastener into the surface.

6.Test the driving depth in a sample piece

before using. If the fasteners are being driven too deep, or not deep enough, adjust the regulator to provide appropriate air pressure. (See Fig. I)

7.Never operate the tool unless the tip of

the nailer is in contact with the workpiece. Do not operate the tool without fasteners loaded or damage to the tool may result.

Release

Bu_on

Fig. H

Fig. I

Regulator

_ Disconnect the tool from the

air supply before performing any adjustments, cleaning, maintenance, or repair.

1.Regular lubrication should be performed if your tool is used without an in-line

automatic oiler. Place 2-6 drops of air tool oil into the air inlet before each workday and after every 2 hours of continuous use.

2.Check all connections and o-rings. Change all worn or damaged o-rings, seals, etc. Tighten all the screws and caps to prevent potential damage or injury.

3.Inspect the trigger and safety mechanisms to ensure they are working properly. Check for loose or missing parts, binding, and/or sticking parts and adjust or replace

ig. F	accordingly.
	4. Keep the nail magazine and the firing tip
	of the tool clean and free of any foreign
	particles or objects.

14 - ENG