Anton/Bauer Nexus Phantom Battery Package owner manual Attaching the Nexus V-Phantom Mount

Page 7

The Phantom mount is attached between the camera and the NEXUS mount. Two separate types of screws are required for the NP mount. These are provided with the NEXUS battery package.

1)Attach the 2 pin wire connector from the phantom mount to the camera.

2)Attatch NEXUS base mount to camera with 4 screws (NP mount only).

3)Attach the 2 pin wire connector and the 1 wire communication connector from the NEXUS battery side of the mount to the corresponding connectors on the Phantom mount.

4)Fasten the 6 screws (provided with the Phantom) of the NEXUS mount to the phantom mount as identified below.

•(4) 1-3/4” screws at bottom four positions

•(2) 1-1/2” screws at top positions.

5)TIGHTEN SCREWS UNTIL YOU FEEL RESISTANCE- DO NOT OVERTIGHTEN.

NP mount

Attaching the NEXUS V-Phantom Mount

5

Page 6 Page 8
Image 7
Page 6 Page 8
Contents Nexus Phantom Battery Package Nexus Phantom Battery SPECIFICATIONS..………..……15 Read and Understand this Manual Before Operation Introduction Features Attaching the Nexus NP Phantom mount Installation of Nexus Phantom housingAttaching the Nexus V-Phantom Mount Charging Nexus PHANTOMV- mount Batteries Phantom Charging Nominal Charge Times for Nexus Phantom Battery Status IndicationsOvercurrent Indication Standard Operation Phantom Battery Oversurge Protection Guidelines Operating Guidelines Service Precautions Nexus Phantom Battery Specifications Limited Warranty Page Anton/Bauer, Inc
Top Page Image Contents