Black & Decker BC40EB Features, Controls and Indicators, Function Buttons from left to right

Page 6

to allow for the maximum proper internal chemical energy transfer. At the end of Stage 2, the charger will automatically move into Stage 3 charge mode.

 

STAGE ONE

 

BEEP

BEEP

 

 

 

 

 

Charge Curve

 

STAGE TWO

 

 

STAGE THREE

 

OFF BEEP

CHARGING

 

COMPLETE

Stage Three — Top-Off Charge voltage is automatically maintained and reduced to a predetermined level while current is adjusted for a safe, effective battery charge. At the end of Stage 3, the unit will BEEP signaling the completion of the charging cycle.

The Automatic Float Charge feature is ideal for maintaining a battery. It automatically tops off battery as needed, keeping it fully charged all the time.

FEATURES

• This unit has four charge rate settings, accessed by the 4/10/20/40 AMP button:

a)4 amps: smaller batteries, such as in lawn mowers, snowmobiles, motorcycles, etc.

b)10 amps: mid-sized batteries, such as in small cars

c)20 amps: automobiles and light trucks

d)40 amps: utility vehicles

110 amp engine start

Automatic Temperature Compensation

Battery type selection

Digital diagnostics

Alternator voltage and battery voltage check

Digital display shows charge rate, operating mode, fault codes and FUL when charged

1-minute engine start

3-stage high-frequency switch mode automatic rapid charging

Spark resistant reverse polarity and short circuit protection for user

Built-in battery reconditioning (desulfate)

Lightweight, high-efficiency design

Internal short circuit protection

Cables and clamps self-stored

Reverse polarity indication

Microprocessor control (Digital Smart Control)/High frequency power

Compensates for low AC from extension cord use

Equalization function

Controls and Indicators

CONTROL PANEL

DIGITAL READOUT CIRCULATING

PATTERN

Function Buttons (from left to right):

Battery Type (Step 1) allows the user to select Wet, Gel or AGM type of battery for efficient and safe charge. Most automotive batteries are Wet batteries. Refer to the battery manufacturer’s specifications for battery type.

5

Image 6
Contents AMP Smart Fully Automatic Battery Charger Save this Manual for Future ReferenceRead ALL Instructions Safety Guidelines / Definitions Locate charger as far away from battery as cables permit Preparing to ChargeIntroduction Features Controls and IndicatorsFunction Buttons from left to right Battery Voltage lights when battery voltage is displayed Operating InstructionsCharge Rate Selection Charging the BatteryDisplay shows FUL when the battery is fully charged Automatic Float ChargingRecondition Mode Engine StartTroubleshooting Approximate Charging TimesAlternator Check Part Care and Maintenance Service Information Full FIVE-YEAR Home USE Warranty SpecificationsAccessories