Lighting Instructions

FORYOUR SAFETY READ BEFORE OPERATING

!WARNING

If you do not follow these instructions exactly, a fire or explosion may result, causing property damage, personal injury or loss of life.

A.This appliance does not have a pilot. It is equipped with an ignition device which automatically lights the burner. Do not try to light the burner by hand.

B.BEFORE OPERATING smell all around the appli- ance area for gas. Be sure to smell next to the floor because some gas is heavier than air and will settle on the floor.

FORYOUR SAFETY “WHAT TO DO IFYOU SMELL GAS”

•Do not try to light any appliance.

•Do not touch any electrical switch; do not use any phone in your building.

•Immediately call your gas supplier from a neighbor’s phone. Follow the gas supplier’s instructions.

•If you cannot reach your gas supplier, call the fire department.

C.Use only your hand to move the gas control switch. Never use tools. If the switch will not move by hand, don’t try to repair it, call a qualified service technician. Force or attempted repair may result in a fire or explosion.

D.Do not use this appliance if any part has been under water. Immediately call a qualified service technician to inspect the appliance and to replace any part of the control system and any gas control which has been under water.

OPERATING INSTRUCTIONS

1.STOP! Read the safety information above on this label.

2.Set the thermostat to lowest setting.

3.Turn off all electric power to the appliance.

4.HSI Models: This appliance is equipped with an ignition device which automatically lights the burner. Do not try to light the burner by hand.

CONTROL LABEL

5.Proven/INTERMITTENT Pilot Models: This appliance is equipped with an ignition device which automatically lights the pilot. Do not try to light the burner by hand.

6.Remove control access panel.

7.Wait five (5) minutes to clear out any gas. If you then smell gas, STOP! Follow “B” in the safety information above on this label. If you don’t smell gas, go to the next step.

8.Push gas control switch to “ON.”

NOTE: Do not force.

9.Replace control access panel.

10.Turn on all electric power to the appliance.

11.Set thermostat to desired setting.

12.If the appliance will not operate, follow the instructions “To Turn Off Gas To Appliance” and call your service technician or gas supplier.

TO TURN OFF GAS TO APPLIANCE

1.	Set the thermostat to lowest setting.	3.	Remove control access panel.
2.	Turnoffallelectricpowertotheapplianceifservice	4.	Push gas control switch to “OFF.” Do not force.
	is to be performed.	5.	Replace control access panel.