Tripp Lite Welding System Mounting optional, Vehicular and Non-Vehicular Horizontal Mount

Mounting optional

WARNING! If you choose to mount your Inverter, mount it and wire its DC input BEFORE DC battery connection. Failure to follow these instructions may lead to personal injury and/or damage to the Inverter and connected systems.

Tripp Lite Inverters are designed for horizontal mounting in a variety of vehicular or non-vehicular applications. User must supply mounting hardware and is responsible for determining if the hardware and mounting surface are suitable to support the weight of the Inverter. Contact Tripp Lite if you require further assistance in mounting your Inverter.

Vehicular and Non-Vehicular Horizontal Mount

C

A Using the measurements from the diagram, install two user-sup- plied ¼" (6 mm) fasteners into a rigid horizontal surface, leaving the heads slightly raised. B Slide the Inverter/Charger back over

the fasteners to engage the mounting slots molded on the bottom of the Inverter/Charger cabinet. C Install and tighten two user-sup-

plied ¼" (6 mm) fasteners into the mounting feet molded on the front of the Inverter/Charger cabinet.

B

▼
7.
87	in
	(20	cm)	▼	▼

A

	▼
	4.
	5	in
		(11.
		4	cm)	▼
▼

▼

.1cm) in(17 .75 6

6PV