Step 5.
Remove your old battery from its seat, using the enclosed plastic flathead screwdriver to assist (as shown) if necessary. Leave the connector plugged in for this process. The battery may be taped or glued in, so pry under it GENTLY until it comes loose. Take care not to break the old battery.
Disconnect the old battery at the connector by CAREFULLY pulling outward on the connector with your thumb and forefinger. Be very sure that you are pulling outward on only the part of the connector that comes out, as shown. Also, note whether the metal connectors shown in the picture above are facing up or down so you can connect your new battery correctly.
Step 6.
Making sure that your battery is facing the right direction (connector towards the bottom of the Clie), and that the metal connectors on the white connector plug (shown in Step 5) are correctly oriented, connect the new battery by pressing the connector at the end of the ribbon cable into the socket as shown. You may need to use the tip of the screwdriver or stylus to press the connector in, but DO NOT press too hard or try to force the pieces together. They will fit easily when correctly aligned. Position the new battery in its seat, placing the protective foil back over the battery and screwing the single internal screw back in to hold it in place (shown in Step 4).
Replace the back cover and screw the four external screws back in. FULLY CHARGE your new battery before use. (Allow at least three hours. For quality control, we
PLEASE NOTE: Our tools fit the majority of Clie’s, but some devices may have different screws installed for various reasons. If our tools do not fit your device, you may have the appropriate tool in a tool kit you already own. You can also check your local hardware or electronics store if you do not have the right tool at home.