3.
2.
1.
If
Harbor Freight Tools is not responsible for damage to the Light or to the vehicle which is a result of improper installation.
Use a rubber gasket (not included) to line the hole and provide protection for the Tail Light. Connect the Terminal Pins to your vehicle’s electric wiring system. Always review the manufacturer’s manual for the vehicle to avoid any damage to the vehicle.
Warning:
Install the Tail Light into a 4-1/2” round hole facing the rear of the vehicle. If your vehicle does not have a hole of this size then drilling a hole will be necessary. Make certain that the hole and connected wiring remain water resistant.
Make certain that the vehicle is OFF and the battery disconnected before installation or performing service or maintenance. Proceed with the following steps for installing the Tail Light.
Installation
Your 4” Flange Mount Tail Light will require complete installation. It is important that you read the entire manual to become familiar with the product BEFORE you install and use the 4” Tail Light. you do not have experience doing this type of electrical work, the job should be done by an automotive service technician.
Unpacking
When unpacking your Flange Mount 4” LED Tail Light, check to make sure that the product is intact and undamaged. If any parts are missing or broken, please call HARBOR FREIGHT TOOLS
at: 1-800-444-3353.
When drilling holes, beware of any hidden electrical lines or cables. Make sure you don’t damage or weaken the structural integrity of the vehicle.
The warnings, cautions, and instructions discussed in this instruction manual cannot cover all possible conditions and situations that may occur. It must be understood by the operator that common sense and caution are factors which cannot be built into this product, but must be supplied by the operator.
10.Always check hardware and assembled parts after assembling. All connections should be tight and hardware tightened.
11.Make certain to follow all local laws regarding vehicles and tail lights.
12.Do not cut or rewire any part of the Tail Light or vehicle.
13Make certain the vehicle is turned off before performing any installation, service or maintenance.
14.Harbor Freight Tools is not responsible for damage to the Light or to the vehicle which is a result of improper installation.
Warning:
SKU 94795 | For technical questions please call | Page 3 |