Harbor Freight Tools 95951 INSPECTION, MAINTENANCE, and Cleaning, After, Use

Page 16

1.Connect the Low Pressure hose to the vehicle A/C system.

2.Disconnect the High Pressure (HP) hose from the auto A/C system.

3.Disconnect HP hose from the High Pressure Connector on the Left Side Panel.

4.Using the High Pressure Hose, connect the Oil Drain Valve (I-13) to the valve of the External Tank (not included).

5.Open the HP and LP Valves on the Control Panel. If the gauges show more than 29 PSI, perform the recovery operation discussed on page 14 before proceeding.

6.Close Oil Drain Valve and Tank Filling Valve. Run Vacuuming Process for the HP and LP Hoses and auto A/C system as discussed on page 13 “Clearing the Hoses”.

7.Add new cooling oil by opening the oil valve as discussed on page 15 “Refilling the

Automotive System with Oil and Refrigerant”. NOTE: Always add cooling oil before adding refrigerant.

8.Open the Oil Drain Valve (I-13). Gradually open the External Tank Valve.

9.The new refrigerant will be drawn into the vehicle A/C system due to the vacuum created in step 6 above.

10.If the refilling process is slow, you may speed things up by starting the vehicle and turning on the A/C system.

INSPECTION, MAINTENANCE, AND CLEANING

1.WARNING! Make sure the Power Switch of the tool is in its “OFF” position and that the tool is unplugged from the electrical outlet before performing any inspec- tion, maintenance, or cleaning procedures.

2.BEFORE EACH USE, inspect the general condition of the tool. Check for loose screws, misalignment or binding of moving parts, cracked or broken parts, damaged electrical wiring, leaking valves, damaged hoses, and any other condition that may affect its safe operation. If abnormal noise, leaking or vibration occurs, have the problem corrected before further use. Do not use damaged equipment.

Maintenance Chart

Maintenance Type

Before

After

Use

Use

 

Inspect tool for damage

X

 

(see #2, above)

 

Wipe off with clean, moist

 

X

cloth

 

Check Refrigerant and

X

 

Cooling Oil level

 

Check Compressor Oil Level

X

 

REV 09h

SKU 95951

For technical questions, please call 1-800-444-3353.

Page 16

Image 16
Contents For technical questions or replacement parts, please call Distributed exclusively by Harbor Freight ToolsGeneral Safety Rules Save This ManualWork Area For technical questions, please callElectrical Safety Personal SafetyTool Use And Care Specific Safety Rules ServiceGrounding Grounded Tools Tools With Three Prong PlugsDouble Insulated Tools Tools With Two Prong Plugs Extension CordsProng Plug and Outlet Outlets for 2-Prong Plug See Table aSymbology Feet120 or 240 Volt At full loadUnpacking Operating Information Indicator LightsControl Panel Gauges LCD Display Valve ControlsFunction Keys SKU For technical questions, please callPreparation Attaching the Recovery / Recharge MachineChecking the Vehicle A/C System Recovery Clearing the HosesVacuuming the System Refilling Using an External Refrigerant Tank Not Included Refilling the Automotive System with Oil and RefrigerantINSPECTION, MAINTENANCE, and Cleaning Maintenance Chart Maintenance TypeAfter UsePlease Read The Following Carefully Parts ListPart Description ’ty Auto A/C Recovery / Recharge Machine Component Groups Group I Left Side Panel Assembly Group II Bottom Panel Assembly For technical questions, please call Limited 90 DAY Warranty Record Product’s Serial Number Here