Specifications
Battery Type | 18V NiCd - SKU 67029 |
|
|
Charger | SKU 67031 |
|
|
Bulb | 10W incandescent, |
|
|
Accessories | Spare Bulb in Lamp Head Housing |
|
|
Unpacking
When unpacking, make sure that the item is intact and undamaged. If any parts are missing or broken, please call Harbor Freight Tools at
Operating Instructions
tool Set Up
To prevent serious injury
from accidental operation:
Turn the Power Switch of the tool to its “OFF” position and disconnect the tool from its Battery Pack before performing any inspection, maintenance, or cleaning procedures.
Instructions for putting into use
Read the entire Important Safety Information section at the beginning of this manual including all text under subheadings therein before set up or use of this product.
Note: For additional information regarding the parts listed in the following pages, refer to the Parts List and Assembly Diagram near the end of this manual.
Functions
Lamp Head Housing (7) | Power Switch (2) |
Lens Retainer (15) |
|
Battery Pack |
|
(SKU 67029) |
|
(Sold Separately) | Figure 1 |
Charge the Battery
The Charger (SKU 67031) and Rechargeable Battery Pack (SKU 67029) are sold separately. Please refer to the 67031 Charger manual for important safety warnings and proper instructions on charging tool.
WARNING! Do NOT use a different Charger or Battery Pack to power this tool.
General Operating Instructions
1.Attach the fully charged Battery Pack (sold separately) to the base of the Flashlight.
2.Slide the Power Switch (2) to ON by sliding it towards the Lamp Head Housing (7).
3.Adjust the direction of the light by pivoting the Lamp Head Housing (7) of the light clockwise, up to 90°.
4.Turn off the Flashlight and disconnect its power supply after use. Clean, then store the tool indoors out of chil- dren’s reach.
SKU 67032 | For technical questions, please call | Page 5 |