Specifications
Electrical Requirements | 110 V~ / 60 Hz / 4.4 W |
Light Strength | 270 Lumens |
Unpacking
When unpacking, make sure that the item is intact and undamaged. If any parts are missing or broken, please call Harbor Freight Tools at the number shown on the cover of this manual as soon as possible.
Initial Set Up
Instructions
Read the entire Important Safety Information section at the beginning of this manual including all text under subheadings therein before set up or use of this product.
To prevent serious injury
from accidental operation:
Unplug the light from the electrical outlet before assembly.
Note: For additional information regarding the parts listed in the following pages, refer to the Assembly Diagram near the end of this manual.
1.Slide the Base (2) into the bottom of the Lamp Assembly (1).
2.Secure with the Knob (3).
Operating Instructions
Read the entire Important Safety Information section at the beginning of this manual including all text under subheadings therein before set up or use of this product.
1.Position the LED work light near the work. Loosen Knob (3) and adjust Lamp Assembly (1) to direct the light beam. Tighten the Knob (3).
2.Plug the Light into a grounded 110V electrical outlet.
3.To prevent accidents, disconnect the power supply after use. Clean, then store the tool indoors out of children’s reach.
REV 09b
SKU 66308 | For technical questions, please call | Page 6 |